Eds Y6 Scratchbuild Gimbal Test - RC Groups
Thread Tools
This thread is privately moderated by ed_jza80, who may elect to delete unwanted replies.
Jan 06, 2013, 10:47 AM
Registered User

Eds Y6 Scratchbuild Gimbal Test

Ed's IAISS Y6 - fine tuning (0 min 32 sec)

a bit of fine tuning and happy days!

theres a bit of lag in the servos during change of direction during large amplitude movements. im not sure if this is servo freq related, or just gear backlash. seems about the same for roll and pitch. ill try it again at 100Hz (currently 50) and see what happens, but ive had enough for today

otherwise, i guess thats what you get with $20 servos (hitec hs82mg). for good quality FPV videos though, i reckon thats not bad - its not meant to be a full AP setup (and doesnt cost as much either!)
Sign up now
to remove ads between posts

Quick Reply
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Anyone did the motor redundancy test for Naza Y6 mode? as my result, it failed... Jason_cx Multirotor Drone Talk 33 Jul 25, 2013 08:03 PM
Gallery Cinestar 8 Gimbal Stability Test and Canon 7D low light test with the Tokina 11-16 HeliVids Aerial Photography 0 Jun 13, 2012 08:45 AM
Discussion Want: Someone to Test a 800mm Box-fuse Pond Racer Scratchbuild molond Foamies (Scratchbuilt) 7 Apr 16, 2012 07:57 AM
Alert For Sale: Heavy Lift Y6 Ready-To-Fly w/HoverflyPro FC, Futaba T10 w/2 rx,& cam gimbal Mactadpole Aerial Photography 4 Dec 27, 2011 01:16 PM