Need help setting up Devo 10 w gimbal and f450! - RC Groups
Thread Tools
Jan 05, 2013, 02:04 PM
Registered User
Discussion

Need help setting up Devo 10 w gimbal and f450!


My buddy has an rc-drones-built f450 w Naza and GPS, along with a Devo 10 tx. he also has the x486 gimbal. and for the life of him and me, we can't figure out how to hook that single servo up and what to do once we do have it properly connected.

so, where does the servo hook up to the RX? if i recall correctly, aux 1 is taken, which leaves aux 2 open. but then how do you program the radio to recognize it?

and then does he go in and mess with the NAZa software?

as you can tell, we have no idea what we're doing. but we r having fun anyway!

thanks.
Sign up now
to remove ads between posts
Jan 06, 2013, 06:34 PM
Registered User
Nobody? Not even rc-drones tony ��?
Jan 06, 2013, 07:30 PM
Registered User
Check your manual. I think you just plug in the servo to the channel on the receiver that you want to use. You're running one Devo and want to program a channel for tilt, right? Try running it off of one of your rotating dials. Trial and error - put it in a few different places until something works.

TB
Jan 06, 2013, 07:31 PM
we dont NEED roads!
AcroFPV's Avatar
the gimbal servos connect to the naza, not the rx.

im sure the naza manual would explain all this.
Jan 07, 2013, 04:27 PM
Registered User
thanks for your help. i'll tell my buddy to RTFM.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion How to Set up Walkera Master CP w/ DEVO 7 TX TazArf Beginner Training Area (Heli-Electric) 9 Apr 20, 2016 12:22 AM
Discussion How to Set up Walkera Master CP w/ DEVO 7 TX TazArf Philippines 7 Mar 09, 2015 10:12 AM
Discussion I have a multiwii control board (that support the 2 axis gimbal. Need help setting up beachflyer Multirotor Drone Talk 9 May 27, 2012 01:15 PM
Discussion Need help with MX 400 & DEVO 10, Please… rcwatchman Multirotor Drone Talk 0 Apr 18, 2012 05:07 PM
Discussion Need help setting a LP5dsm up to buddy box W/dx6i pops57 DIY Electronics 1 Mar 16, 2012 05:33 PM