Roll gimbal not working at all with Naza
I've got a Gator mount on my flamewheel 450 frame, and for some reason the roll gimbal has just quit working. I just upgraded the Naza to the latest firmware, disconnected everything & reconnected, re did calibration, gimbal settings etc. and still nothing. I even hooked up another servo to the F2 channel to make sure that was not the problem, the servo has barely any perceptible movement when I roll the frame by hand.
I even switched the F1 & F2 connections around and the pitch would then work when I did roll movement on the frame, but nothing on the roll when applying pitch to the frame. So it appears the F2 output is not working at all.
Any ideas how I can rectify this?
update - turns out it was the servo, after reading what I wrote and thinking about it I figured it must be, so went and found another servo and it was ok - first one I tried in place was a dud too..
Last edited by Glenstr; Jan 04, 2013 at 12:12 AM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||DJI NAZA gimbal roll servo glitch||joshidharmesh||Multirotor Drone Talk||7||Dec 10, 2012 07:02 AM|
|Question||Weird problem with New Y-6... Throttle works, but not Pitch Roll or Yaw||Adidas4275||Aerial Photography||4||Apr 02, 2012 11:21 AM|
|Help!||EagleTree Ground Station - Diversity does not work at all, why?||lordon||Eagle Tree Systems||12||Jun 07, 2011 01:29 PM|
|22a walkera not working at all. 3-1 to blame??||gordthebiker||Micro Helis||3||May 07, 2005 01:44 PM|
|Alierons on a GWS cub, will they just not work at all?||Thomas Manson||Parkflyers||2||Jul 16, 2003 10:36 PM|