Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by MassiveOverkill, who may elect to delete unwanted replies.
Old Jan 02, 2013, 05:32 PM
MassiveOverkill is offline
Find More Posts by MassiveOverkill
Registered User
MassiveOverkill's Avatar
Discussion

V939\V202 LED Mod


The LED holders on the WL toys V939 and V202 quads mask alot of the LED light. In addition, on a hard crash you can lose them. Not to worry. Simply take some heat shrink and pre-shrink it on a screwdriver shaft and slide it over the LEDs

I used 3\16th shrink tubing and just picked a Philips head screwdriver that was slightly smaller than the diameter of the LED holder. Cut the heat shrink to about half the length of the stock holder. You can always trim after you shrink it as well.

Heat shrink cut and ready to be shrunk:



Shrunk:



Installed, compared to stock holder (left is stock, right is heat shrink):



Light test, left is new, right is stock:







Now the V939\V202 can give the Mini Pet a run for its money at night Thanks to Bill for the idea to use heat shrink.

There's also a straw mod you an do by simply cutting some short lengths of straw and placing them over the existing LED holders for that fiber optic effect:

https://www.rcgroups.com/forums/show...0#post24554334
RCG Plus Member
Last edited by MassiveOverkill; May 11, 2013 at 07:54 AM.
Sign up now
to remove ads between posts
Old Jan 03, 2013, 05:52 PM
skyenzo is offline
Find More Posts by skyenzo
quad addict
Quote:
Originally Posted by MassiveOverkill View Post
The LED holders on the WL toys V939 and V202 quads mask alot of the LED light. In addition, on a hard crash you can lose them. Not to worry. Simply take some heat shrink and pre-shrink it on a screwdriver shaft and slide it over the LEDs

I used 3\16th shrink tubing and just picked a Philips head screwdriver that was slightly smaller than the diameter of the LED holder. Cut the heat shrink to about half the length of the stock holder. You can always trim after you shrink it as well.

Heat shrink cut and ready to be shrunk:



Shrunk:



Installed, compared to stock holder (left is stock, right is heat shrink):



Light test, left is new, right is stock:







Now the V939\V202 can give the Mini Pet a run for its money at night Thanks to Bill for the idea to use heat shrink.


nice mod!

genial idea!

going to mount as soon as will arrive new pcb spares!

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion LadyBird Qr SMD Led's mod, even more led's to come! croyal918 Multirotor Talk 6 Jan 13, 2014 08:15 PM
Mini-HowTo V911 Night Glow (Canopy LED Mod) and Maiden Flight mrmarc Micro Helis 25 Mar 11, 2013 06:20 PM
Build Log Slow Stick for AP with Mods, Aiptek cam mod, Strip LEDS for night flight(Plane RTF) TaSaJaRa Aerial Photography 44 Sep 08, 2009 10:01 AM
Discussion Even easier LED mod..... no show and 2 LEDs! Ironbowser Micro Ready-to-Fly 4 Sep 02, 2008 07:42 PM
Discussion New LED source at Walmart & Doing the LED mod KC Micro Ready-to-Fly 7 Mar 18, 2007 07:45 PM