SD-10G /USB cable Xplorer 3.5 set up
Hello Guys, Looking for help using the USB data transfer cable to download a program from my PC. I have a setup that Websolution kindly sent for my Version I Xplorer 3.5 ST . The issue is I cant figure out how to get the file into the transfer program and select it for transfer to the transmitter. The program and USB cable seem to work properly the green light lights up on the usb and the radio is set and ready to accept via a pc to tx transfer. How do I select the file I want to transfer, the file looks like an adobe file not a zipped file like I have seen on other threads.Where do I select the specific file and how do I get it ready to transfer, all I show on the pc/usb program is a little box that reads com port 3, and below that is that I check off as transfer PC to Tx, I cant get the program file selected to allow uploading to the radio. Maybe the file is the wrong type??? Any suggestions or Xplorer set ups files welcome. Thanks Jack.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Need help setting up Elevons on SD-10G||tlh101||Radios||1||May 20, 2012 03:43 PM|
|Wanted||airtronics sd-10g usb cable||gshort72||Aircraft - General - Radio Equipment (FS/W)||5||Jul 15, 2011 11:43 AM|
|Wanted||SD-10G usb cable wanted||Ron Clarkson||Aircraft - Sailplanes (FS/W)||0||Dec 23, 2010 02:12 PM|
|Wanted||SD-10G usb cable wanted||SoaringDude||Aircraft - General - Radio Equipment (FS/W)||0||Nov 23, 2010 11:18 PM|
|Wanted||SD-10G usb cable wanted||SoaringDude||Aircraft - Sailplanes (FS/W)||2||Oct 08, 2010 02:29 PM|