Nxy - RC Groups
Thread Tools
Dec 08, 2012, 12:13 AM
Registered User
bluffman's Avatar


I recently aquired a new NYX, its fuse is carbon kevlar fuse, I am using JR I have a carbon receiver with a carbon satellite, I have the satellite receiver antenai exiting the fuse through the launch peg hole in bottom of fuse, now I am trying to figure out where to have the two antenai on the main receiver exit, before the hatch or behind the hatch 2" in front of the wing, any suggestions would be appreciated, I will have pictures tomorrow. Ian
Sign up now
to remove ads between posts
Dec 08, 2012, 01:21 AM
tpczx6's Avatar
I have a NYX with Fr-sky and i put my exits right at the end of the hatch about mid way down. I have had the NYX at spec hight whendoing some F3B with no issuse. Hope this helps
Dec 08, 2012, 12:11 PM
Eagle Butte User
PDX Slope Pilot's Avatar
Mine also usually end up midsection or towards the rear of the canopy and about 20-30mm down from the opening and out on a 45*. Attached is a good article on the subject.

Dec 08, 2012, 12:55 PM
Detail Freak
target's Avatar
Whats a NXY?

OK, so just bustin Ian's chops on the typo....

On carbon/kevlar+carbon fuses, use the 9300 or 9310 Rx and run the two ant's from the main Rx out the sides at 45 degree swept back angles, on the horizontal plain, ahead of the wing.
The satellite can go aft of the wing somewhere, poking straight out.
Some guys have mounted satellites in the vertical fin, extending the connecting wire to the main Rx as needed, and that works well also.

Last edited by target; Dec 08, 2012 at 01:35 PM.
Dec 08, 2012, 09:21 PM
Registered User
bluffman's Avatar
I thank you guys for your input on my NXY, I should always wear my glasses. NYX

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale Nxy Furio F3F V-tail Eddie.C Aircraft - Sailplanes (FS/W) 8 Aug 17, 2010 06:28 PM