Thread Tools
This thread is privately moderated by hutchinstuff, who may elect to delete unwanted replies.
Dec 05, 2012, 09:50 PM
Hutch
hutchinstuff's Avatar
Thread OP
Discussion

Flying start put together!


There isn't much to show on the build, but here are the final pics. The gear is made from a piece of AL, used the nibblers to cut it in half. The gear kept splayin out, so I cut one of my wifes hair ties, then drilled out a hole in the AL, put an end through and put a half hitch on it. Hair ties work great for bungees, and are cheap too!
HK gyro to make the video stable on the front.

She is a bit overpowered, but it gets off the ground quick, which is nice as I like to film in some tight areas.

comment if you have any qs!
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Putting together a lipo pack for an E-Bike Msioni Batteries and Chargers 23 Jun 11, 2018 03:55 PM
Starting to put together my Filip-E (any tips?) kbw99 Electric Sailplanes 375 Oct 14, 2012 06:34 AM
Sold Skywalker v1.5 fully put together 200$ (plus real shipping cost) wootenelli FPV Equipment (FS/W) 0 Apr 27, 2012 03:34 PM
Discussion Putting a Katana MD together..... pmccook1 3D Flying 2 Apr 24, 2012 10:33 PM
Discussion Put together a little indoor flying Video (with aerial video too) cannondale1974 Scratchbuilt Indoor and Micro Models 0 Mar 09, 2012 12:04 PM