Thread Tools
This thread is privately moderated by SkyCadet, who may elect to delete unwanted replies.
Old Nov 29, 2012, 01:39 AM
SkyCadet is offline
Find More Posts by SkyCadet
Segelfliegen bedeutet Freiheit
SkyCadet's Avatar
Discussion

Servos installed, RX tray and fuselage gear reinforcements/tinting done!


I finished installing the servos, into both the wings and tail. Ran a 12" extension on the servos in the tail, and will be using HK servo wire clips on the wings so that a Y harness can affix the wing servo connections.

Also paint-tinted the outer fuselage front and epoxied the RX tray onto the rear runner behind the battery tray.

I used CF rod/1" balsa blocks on the mains for reinforcement, pictures shown below... Now, just motor, setting the horn throws, and then connecting the electronics!

SkyCadet
RCG Plus Member
Latest blog entry: New plane - Evader!!!
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Fuselage Servo Mounting Tray nlpken Aircraft - Sailplanes (FS/W) 2 Mar 13, 2010 09:20 AM
Discussion Glider RX install in full carbon fuselage Vingen300 Xtreme Power Systems 29 Jul 16, 2009 06:08 PM
Wanted Starmax HL F-18 rx tray, battery tray and nose gear Joe 1320 Aircraft - Electric - Jets (FS/W) 7 Sep 16, 2008 09:56 PM
Discussion Installing servos in the fuselage balsaaddict Hand Launch 9 Jun 23, 2008 10:20 PM
Discussion Horizontal installation of fuselage servos - Vöster Pilatus B4 jcosta Scale Sailplanes 13 Nov 05, 2006 05:53 PM