It's been a while - RC Groups
Thread Tools
Nov 22, 2012, 07:42 PM
Registered User

It's been a while

So....haven't built anything other than free flight in a while....busted out an old xp4 blank I had and started building as Tom is supposed to be really nice and I thought hey some dlg would be fun....anyway I didn't have a rec. so went all in on a 10g and some new Rx's....the one I decided to drop into the plane is a92664.... Well the booklet gives crazy info for the Channels and so I just started plugging and....the rudder and elevator seemed fine so i plugged the wing servos into 3 and 4 channels and turned her on to center the throws......well the damn servos rotated like 180 degree and ripped themselves right out of the wings ....I cannot remember how to determine the correct channels for this rx and luckily the wing isn't damaged yet....and I was patting myself on back for figuring out how to bond the rx and remembering how the darn triton charger works......any help?
Sign up now
to remove ads between posts
Nov 22, 2012, 08:10 PM
excelling at mediocrity
gopherhunter's Avatar
800 ft range on that receiver. I use an SD10G. The 10G allows you to assign any control function to any channel. It sounds like you just need to reverse the wing servo directions in the SURFACE menu. Reciever channel assignments is in the SYSTEM menu. Hope this helps.

Nov 23, 2012, 09:52 AM
Registered User
Txvm worked a charm... Installing peg now ha

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question What's the "state of the art" for 70mm fans? ...been out of it for a little while MRGTX Foamy EDFs 28 Dec 12, 2012 02:27 PM
Discussion Its been a long while between drinks sgeprods Aerial Photography 8 Jul 11, 2012 05:03 AM
Discussion been outta the game for a while, looking for charger... clonedkorl Batteries and Chargers 3 Apr 11, 2012 09:22 AM
Help! First charge of Lipo after it's been sitting for a while BillzillaAus Batteries and Chargers 10 Mar 27, 2012 08:57 PM