Thread Tools
This thread is privately moderated by RSTEARMAN, who may elect to delete unwanted replies.
Nov 20, 2012, 10:29 PM
Trader Rating: 61
Registered User

Water bottle gas tank fittings / bulkhead fuel line fittings

High quality 1/8 inch to 1/8 inch bulkhead fittings

Nickel plated

Tested to 120 psi

Use the same fitting tor the vent, simply remove the nipple on the threaded end

Made in USA

$2.85 each

$1.95 shipping for 1 to 15

Only six left
Sign up now
to remove ads between posts
Nov 20, 2012, 10:43 PM
Trader Rating: 45
Scale Aerobatic Pilot
PropsnWings's Avatar
How does the nipple simply remove? Trying to see what you mean by the pictures.

Do these have a neoprene washer, or O-ring to seal when snugged?
Nov 20, 2012, 11:00 PM
Trader Rating: 61
Registered User
The nipple is made of nickel plated brass and is easily cut off with a hack saw. If you need some with just the threads on one end, I can made some up for you.

No O-ring,

Just be sure to drill the correct size hole so that the nipple threads into the plastic.
The plastic that the bottle is made of is a good gasket material.
Last edited by RSTEARMAN; Nov 20, 2012 at 11:08 PM.
Nov 21, 2012, 10:35 AM
Trader Rating: 61
Registered User
All sold

Thank you

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale Large lot of fuel tanks for glo or gas Steve H. Aircraft - Fuel - Engines and Accessories (FS/W) 0 Jul 31, 2012 10:30 PM
Sold Gas Fuel Tank Stopper, Aluminum Standoffs wolfcbr2003 Aircraft - Fuel - Engines and Accessories (FS/W) 0 Jul 27, 2012 01:02 PM
Question I don't understand... 1/8 fuel tube, sloppy fit on tank pipes? 30cc extra330sc build The knifes edge Engines 11 May 01, 2012 01:42 AM
For Sale 4TITUDE gas fuel tank with mount and line JackRC Aircraft - General - Miscellaneous (FS/W) 0 Oct 06, 2011 11:58 PM
Discussion Gas engine => fuel tank/line/engine set-up... Commplexxo Scale Sailplanes 7 Apr 24, 2011 08:26 PM