DJI Warranty issues??? - Page 2 - RC Groups
Thread Tools
Nov 20, 2012, 08:48 AM
Registered User
hexa's Avatar
No beating around bush defending Dji.
The pilot is not to blamed for craft crashing from faulty props.
Dji sell kits with faulty weak props. So many people have report this and still they sell the same faulty props.

The only reason why they don't want to replace your craft is because in Dji's eyes you spent petty cash.
Dji only look out for the ones who buy their high end stuff and not the lower end stuff.

It's like they are saying tuff luck screw you.

It's a shame as for sure they do make more money from the lower end stuff over the high end.

Equal rights and justice for all. Wink wink
Sign up now
to remove ads between posts
Nov 20, 2012, 04:25 PM
Registered User
Best lesson I have learned after seven years of flying big AP birds with lots of dissapointing problems? Buy EVERYTHING with Mastercard or Visa. When things go south fill out a disput with mastercard or visa. You get a fair oversight from a third party and if you are right the vendor doesnt get the cash you spent. You will get a refund . Complete refund and the vendor gets their crap back in a box
Nov 20, 2012, 05:16 PM
Registered User
hexa's Avatar
That's a good pointer.
In this case it would be the smaller man the retailer who would get stung.

Wile the head honcho who should sort the matter as its their fault, do nothing.

With Dji products its the retailers - Dealers that's get all the dirty work.

Eg replying to hundreds of emails, trying to help their costumers with matters some time which is not related to them as the retailer.
Last edited by hexa; Nov 20, 2012 at 05:21 PM.
Nov 20, 2012, 07:20 PM
Connecticut Quad Hacker
batfire's Avatar
One comment I would inject here since no one has mentioned it. It may or may not be issue on your copter.........

Never use any type of loctite, doesn't matter if its blue or plastic type, or you will have prop failures.

I have many flight HOURS with multicopters testing systems etc...... and I now get many hours out of stock DJI, XA props that were snapping for no apparent reason.

There is always a reason why things fail; you just need to find that reason. In many cases with props its loctite. Further more loctite should not be used on copters anywhere near props or plastic. You can use silicone instead for shaft so prop doesn't become permanent attachment to shaft. You will find if you use thin nylon washer (optional) and torque crown nut or nut to 1/2lbs of torque you will cure a lot of issues in one shot. But that is another subject.

Hope this helps.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion DJI Naza gimbal level issue linked to FFF issue slidins15 Multirotor Drone Talk 35 Sep 07, 2012 12:08 AM
Alert "Warranty" credit finally issued after 8 months!!!!!!!!!!!!!!! -= GYRO =- HobbyKing 0 Mar 19, 2012 11:04 AM
Help! DJI Naza wind issue!!!! (help needed with throttle up issue in wind) Arxangel Multirotor Drone Talk 11 Mar 07, 2012 02:47 AM
Discussion "Warranty" provided by DJI - means absence of warranty ! Zmeyuko Multirotor Drone Talk 56 Mar 05, 2012 03:17 AM
Discussion Does the DJI f450 Frame Have Vibration Issues? ukarmy04 Multirotor Drone Talk 0 Dec 31, 2011 01:53 PM