ORX 3AS installed and ready for trials! - RC Groups
Thread Tools
This thread is privately moderated by SkyCadet, who may elect to delete unwanted replies.
Oct 26, 2012, 01:18 AM
Segelfliegen bedeutet Freiheit
SkyCadet's Avatar

ORX 3AS installed and ready for trials!

I just finished installing my ORX 3AS unit tonight.

Install was pretty easy. I took the cover off my unit to save some weight, it was too difficult to remove the board out of the unit. Since I am trying this first on my 3-channel Super Decathlon BL, I ran the aileron and elevtaor channels only. Gain on the rudder is set to lowest. I set the two other axes for around the "2-oclock" position approximately, and set a medium low compensation throw for both axes, to not overly correct flying.

This model is especially authoritative on the rudder, so I had to make sur ethe plane is not going to overly correct that axis.

I think that I have gotten them just right, but maidening with the system running tomorrow (day off - YAY!) may tell the story. I wil post results when they arrive... FYI - the unit just slightly runs the servos under idle on mid-mid high gain.

Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale HK450 FULL set, ready to fly, all installed, flown few times Dzozi-POL Aircraft - Electric - Multirotor (FS/W) 0 Mar 19, 2012 08:11 AM
Build Log Stinson Reliant 18" Span 1/28 Scale Rubber Conversion ( ready for another trial) GJ60 Scale Kit/Scratch Built 127 Oct 30, 2009 06:42 PM
Shrink for 2/3As HVAC25000 Electric Plane Talk 2 Aug 23, 2005 11:50 PM