Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Oct 25, 2012, 01:50 PM
WVrailfan is offline
Find More Posts by WVrailfan
Registered User
WVrailfan's Avatar
Discussion

Display with nav lights "on" question


I have been invited to display a couple of my planes at a CAP seminar and banquet. I would like to put a battery in one with nav lights for the display.

Will it hurt the receiver or other components to have power to them for extended periods of time?

Jim
Sign up now
to remove ads between posts
Old Oct 25, 2012, 02:33 PM
gnofliwr is offline
Find More Posts by gnofliwr
aka: A.Roger Wilfong
gnofliwr's Avatar
It all depends. Assuming your lights are run off the radio power circuit, then...

If you're using a seperate radio battery, running the radio without the transmitter may result in erratic, uncontrolled servo movements. The servos may run against the stops and could be damaged. It all depends on what your radio system does when the Rx is on and the Tx is off.

If you going to run off of the motor battery, through a BEC, you can add to the above the potential of the motor starting up unexpectedly. If this is the case, consider removing the prop and/or disconnecting the wires between the ESC and motor.

Why not just temporarily unplug the lights from the radio power buss and use an independent radio batter to power the lights during the display?

- Roger
Old Oct 25, 2012, 02:36 PM
WVrailfan is offline
Find More Posts by WVrailfan
Registered User
WVrailfan's Avatar
The lights are just plugged in to an unused channel on the reciever.

I have a couple of 2 cell batteries I don't use any more, I may just make an adaptor and see if the lights will run off of that for a while.

Thanks
Jim
Old Oct 25, 2012, 02:57 PM
Darryl Miller is offline
Find More Posts by Darryl Miller
R/C Addict for Life!!
Darryl Miller's Avatar
Your solution will work, just dont use a 7.4 volt 2 cell lipo..........it would be too much. If your lights run off a reciever channel, they are set up for 4.8 volts. Try a one cell lipo, or a couple AA-s first to see if it works.

D
Old Oct 25, 2012, 06:56 PM
Johnny Five is offline
Find More Posts by Johnny Five
Registered User
Johnny Five's Avatar
You could use a reciever battery pack and unplug everything but the lights. I would be tempted to use another reciever to power the lights and leave the plane reciever alone.

http://www.headsuprc.com/servlet/the...IES/Categories
Old Oct 26, 2012, 01:26 AM
MattZC is offline
Find More Posts by MattZC
I just love flying
MattZC's Avatar
I've been using a servo-testor to run my lights during my recent build.

Matt


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question How Can I Hook Up the Included Nav Lights On my Plane? ClevelandBaller Electric Plane Talk 11 Aug 13, 2012 11:49 PM
Discussion MQX with LED Nav Lights Ron_RC Night Flying 0 Apr 10, 2012 04:57 PM
Alert Nav lights at poundland uk ballores Night Flying 0 Feb 23, 2012 01:32 PM
Discussion airfield sky trainer 55 inch with flaps and nav lights connector question?? flysohigh Electric Plane Talk 1 Apr 27, 2011 12:03 AM
Question Xtreme Battery Alarm & Nav Lights modification question? Mactadpole Power Systems 0 Apr 26, 2010 07:19 PM