|Great Planes Gee Bee R1 EP Tx-R|
|Wing Area:||241 sq in|
|Wing Loading:||20 oz/sq ft|
|Servos:||9 gram micro|
|Receiver:||Tactic 2.4GHz SLT|
|Battery:||FlightPower 3S 11.1V 2200mAh 30C Lipo|
|Motor:||1000 kV Brushless Outrunner|
|ESC:||35 Amp Brushless ESC|
|Power WOT:||27 Amps = 335 Watts = 156 Watts/lb|
|Transmitter Adapter:||Tactic AnyLink Module|
|Transmitters:||JR 9503, Spektrum DX18, Spektrum Dx5e, Futaba 8FGA Super, Futaba 6EX, Tower 4TH|
|Available From:||Hobbico Dealers and fine Hobby Shops|
In 1932, after only three days of wind tunnel testing at NYU, the legendary Granville brothers emerged with a revolutionary design for a Thompson Trophy racer. That design would be called the R1. The plane sported a teardrop shaped fuselage that flowed back from a huge Pratt & Whitney R-1340 Wasp radial engine all the way to a tiny cockpit and tail. The rearward pilot location was supposed to afford the pilot a better view of the race course when rounding pylon turns, but I think it may have had more to do with offsetting the weight of that giant radial engine up front. The famous Jimmy Doolittle piloted the original Gee Bee R1 to victory in the 1932 Thompson Trophy Race and then set a new world speed record of 296 mph in the Shell Speed Dash. Doolittle said the R1 was "the sweetest ship I've ever flown." Unfortunately the R1 would later develop a darker reputation due to a number of fatal crashes at the hands of less proficient pilots.
Lucky for us, Great Planes has set out to lighten that reputation. They have created a beautiful scale model of the Gee Bee R1 that is actually easy to fly. The new Gee Bee is available in both Rx-R and Tx-R configurations. Now almost any RC pilot can fly this legendary racer.
Recommended by Great Planes and supplied by Hobbico for this review:
Tactic TR624 Receiver
|Frequency Band:||2.4 GHz|
|Type:||FHSS Spread Spectrum|
|Number of Channels:||Six|
|Range Classification:||Park Flyer (1000')|
|Weight with case:||8g/0.28 oz.|
|Power:||4V - 6V|
FlightPower 30C LiPoly Battery
|Number of cells||3-cells|
|Dimensions (L x W x D)||107 x 36 x 26mm|
|Maximum continuous discharge||30C|
|Maximum continuous current||66 amps|
The 16-page Instruction Manual includes numerous illustrations and pictures and helpful building tips. All the hard parts have already been done, so assembly takes less than an hour. Stringing the elastic cord "flying wires" through their various locations is the most tedious part of the build, and it's optional. I have to admit, I skipped this step, but the cord is included and the "wires" certainly add to the scale looks of the Gee Bee.
The assembly process begins with the fuselage. The elevator halves slide together and are held in place by magnets. The bottom of the stab has a ridge and the bottom of the fuselage slot has a groove to help with orientation.
Once the elevator pushrod was hooked up, the fuselage assembly was complete.
The one-piece wing only needed the wheels to be complete. Each wheel assembly had some nice two-piece wheel pants that were held together with magnets.
The finished look with the wheels in place was really sharp. The completed wing assembly attached to the fuselage with a single mounting screw.
All of the flight radio gear is already installed in the Gee Bee, so this section will explore installing the AnyLink transmitter module to six different transmitters. For a full list of compatible transmitters, check out the AnyLink compatibility chart for complete details.
Before I began any testing on my six different transmitters, I needed to observe several safety precautions. I needed to remove the prop from the motor, determine the correct travel direction for the throttle channel, and map the channels for the correct control sequence.
|Gee Bee AnyLink Intro (1 min 26 sec)|
Once the plane was safely secured, I could begin testing the AnyLink module.
|Futaba 6EX w/AnyLink (2 min 16 sec)|
|Futaba 8FG w/Anylink (3 min 12 sec)|
|Tower TX w/AnyLink (2 min 3 sec)|
|JR 9503 TX on AnyLInk (4 min 7 sec)|
|Spektrum DX5e TX on AnyLink (3 min 45 sec)|
|Spektrum DX18 TX on AnyLink (3 min 42 sec)|
The AnyLink module worked Flawlessly with all of the transmitters! This technology now allows almost any brand of transmitter to operate any of the new fleet of Great Planes Tx-R models.
The completed Gee Bee weighed 2 pounds and 2 ounces RTF. With a fully charged battery and the provided propeller, the 1000 kV outrunner pulled 27 Amps for a static power loading of 335 Watts. That's just over 155 Watts per pound of power.
I moved the battery all the way forward in the battery compartment to get the CG to the recommended 1-1/4" point. For the first flight I set the control surface throws at the recommended amounts for low and high rates and programmed in 25% exponential on low rates and 35% exponential on high rates. For later flights I moved the CG back 1/4" to improve aerobatic performance.
The original Gee Bee was a no-nonsense racer, so I was a little worried about how this model would fly. I should have known that Great Planes would tame down this little racer so mere mortals would be able to fly it with confidence. I was pleased to find that this Gee Bee was very mild mannered and even easy to fly.
With its narrow wheel spacing and the large gear covers, the Gee Bee needed a paved runway and a straight line into the wind for takeoffs. I needed to hold just a little up elevator to keep the tail wheel down and the nose tracking straight, to get the little racer airborne.
Landings were more challenging for me. I found that my best landings occurred when I carried a little airspeed all the way to touchdown and then kept the plane straight into the wind all the way to full stop.
The Gee Bee was rock solid in the air and flew like a pattern plane. Low rates produced leisurely rolls and large loops. High rates were just about right for my normal style of flying. Knife edge flight was excellent due to the generous amount of side area from that teardrop fuselage. With the recommended CG location, the Gee Bee didn't want to snap or spin very well so I moved the battery back and improved both.
Not so much. However, pilots with intermediate flying skills should have no problems.
Here is the Gee Bee racer flown with a Spektrum DX18 Transmitter.
|Gee Bee Flight Dx18 Transmitter (3 min 38 sec)|
Great Planes has done an excellent job of developing and providing this new Tx-R technology for the RC enthusiast. The AnyLink transmitter module allows almost any transmitter to fly this new Gee Bee racer and numerous other new Tx-R aircraft.
Nice review. This is one in my fleet. I have a 3 axis gyro installed and it helps tame it quite a bit. Landings are still the challenge. Some have replaced the rigging with carbon fiber or wire to stiffen up the wings and especially the landing gear. I speculate this will help quite a bit. Search the other thread for some examples.
Here is an earlier review of the Great Planes Gee Bee racer by Mike Herr:
Mike's review subject was the Rx-R version, but the plane is the same. You can check out the videos of the landings in that review if you like.
Here is the Great Planes promotional video that shows a landing:
While my review subject was the Gee Bee R1, the AnyLink system functionality was a central focus for the review. I was trying to show the versatility of the AnyLink and the fact that it worked with every transmitter I tried. In addition to the ground testing for functionality, I have flown the Gee Bee racer with the Futaba 6EX, Futaba 8FGA Super, JR 9503, and the Spektrum DX18 transmitters. The AnyLink system was solid as a rock with all four transmitters.
Since I prefer exponential and dual rates for flying, I have not flown the plane with the Dx5e or Tower transmitters. Maybe I should give them a try. They might improve my landings.
Last edited by kingsflyer; Feb 27, 2013 at 03:35 PM.
Nice job on the review...well done.
However, I have to say that this model does not do the Gee Bee R-1 justice, with the stretched fuselage. Simply ruins it for me. I understand why they stretched the fuse, but it is too much of a deviation from scale to be enjoyable for me.
I have and fly the uMX Gee Bee (love it) and still have a venerable but nearly worn out FanTastic Model Gee Bee hanging up in the model room. Both are quite a bit more scale looking than the Great Planes foamie.
A well designed lightweight Gee Bee at the size of the Great Planes model simply does not need to the fuse to be stretched to fly well.
Thanks Thomas. I was very impressed with the AnyLink technology that Great Planes is offering.
While I understand your concern for the deviation from exact scale, I appreciated the improved flight stability that the stretched fuselage gives this Gee Bee. So far, everyone that has seen the model at the field knows that it's a Gee Bee. To date, nobody that has seen my model in person has mentioned that the fuselage looks too long.
Last edited by kingsflyer; Mar 09, 2013 at 09:05 AM.
Thanks for mentioning my review Mike. Flyzone's new Corsair has a slightly stretched fuselage and it really helps make it a great flyer. I will take slight deviations for improved handling and flight characteristics. No one has mentioned that my Gee Bee was too long but comparing it with scale pictures I know Tom is right about size but it doesn't lower my opinion of the plane. In this hobby 100 people will probably have 60--75 different views. The video in my Arizona Electric Festival article has a nice video of the Corsair in action. I am looking forward to Dr. Dave's review of it when the approximate two feet of snow he got this week melt and he can get back in the air with it.
I am a fan of the AnyLink system and I am looking forward to their new transmitter, the Tactic TTX650 which is due out in March. It has a 20 model memory and works with the Tactic AnyLink receiver and is for both planes and helicopters. Tower is selling three of the receivers for $50.00 and I have mapped out a spot on a local mountain highway to do a scientific range check of the system. I have had no range problems with the AnyLink system but want to get some hard data for my review of the new transmitter when it arrives.
Enjoyed your review Mike! Mike H
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Article||ElectriFly Gee Bee R-1 Ep Rx-R Review||Michael Heer||Scale ARF/RTF||43||Jan 05, 2014 10:29 AM|
|Sold||Great Planes Gee Bee R-1 EP RxR $100 Shipped U.S.||Gargamelmohaynow||Aircraft - Electric - Airplanes (FS/W)||2||Jun 09, 2012 04:03 PM|
|Sold||Great Planes Gee Bee R-1 EP Rx-R LPU Melbourne, Florida||fltekdiver||Aircraft - Electric - Airplanes (FS/W)||6||May 03, 2012 07:57 PM|
|Sold||NIB Great Planes Gee Bee R-1 Brushless Rx-R 38.5" $130/obo||irishfour||Aircraft - Electric - Airplanes (FS/W)||4||May 02, 2012 05:22 PM|
|Sold||Great Planes Gee Bee RX-R Airframe minus MTR Mount||Maddog20||Aircraft - Electric - Airplanes (FS/W)||2||Mar 15, 2012 05:21 AM|