Speedo MKIII fit out - RC Groups
Thread Tools
This thread is privately moderated by FWAL, who may elect to delete unwanted replies.
Oct 22, 2012, 03:57 PM
Flying without a licence
FWAL's Avatar

Speedo MKIII fit out

I'm calling it a fit out rather than a build as there is so little to do. The Ail's and elevator are pre hinged and all the required holes have been pre-drilled inc servo fixings and control horns. The stab is housed out and fits into a cut out out in the tail really nicely. The elevator control rod splits into two in the boom and exits on each side of the tail. I have added a bit of strength to the rod near the servo tray as it was bending slightly. I have also added another layer of GRP to the canopy as that too was flexing a bit more than I liked.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion New version of speedo? Speedo Pro! slope junkie Slope 303 Sep 20, 2017 05:49 AM
Discussion Speedo Pro vs. Speedo Pro Lite Up&Away Slope 4 Oct 27, 2012 12:37 AM
Sold Hobbico Digital Voltmeter MkIII and Scale Voltmeter cargopilot Aircraft - General - Miscellaneous (FS/W) 2 Aug 26, 2012 07:37 PM
Help! Dodgson-Maestro MKIII Plans jolly01 Sailplane Talk 0 Aug 09, 2012 08:01 AM
Out fitting a Tipsy, where to get 280 motor? rojoyinc Parkflyers 1 Apr 28, 2002 10:00 PM