I ordered and received the AEO ADF30-100 PLUS 8000KV. In testing, I cannot get it to run beyond a very low throttle setting.
I have tried ESCs at 12A, 18A and 25A with the same result.
I have tried 3-3 cell battery packs at 1500, 2100, and 2600 (all 25-25+C)mAh capacity, all with the same result.
The result is that the unit will start, but with advancing throttle, it cuts off. The current when this happens varies between about 3A and 7A, but if it peaks higher, I can't tell.
Do I need a special hi-freq ESC for this? Is my result a hardware fault or operator error?
Not personally seen a hobbywing on HK site for some time.
Did discover that an esc with an "atmel' chip seems to deal with high outrunner rpms though.
Plush...ones in red heat shrink..did !
Clear shrink versions currently use a silab(?) chip . No idea if it's better or worse at this, although some claim it a degrade.. but that's just words until proven..
Not all that easy to deduce from brochure babble which esc's actually currently use a capable chip though.
Mystery / HK blue series still do (did?)
Dunno if that helps in selecting ?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Aeo edf with ammo 10/11500kv||nadine||Micro EDF Jets and Power Systems||7||Sep 23, 2012 12:38 AM|
|Discussion||AEO-RC CR23L Contra-Rotating Motors (Semi Heavy Lift?)||gitit20||Multirotor Talk||3||Jul 06, 2012 09:38 PM|
|Sold||XP-7A and AEO converter||SYMAWD||Aircraft - Electric - Helis (FS/W)||0||Jul 01, 2012 10:07 PM|
|Sold||New head tracker aeo x-gyro 1000||TBello||FPV Equipment (FS/W)||2||Apr 29, 2012 09:58 AM|
|Discussion||AEO brushless problem... HELP!!!!!||jbeauvil001||Micro Helis||8||Apr 08, 2009 07:22 PM|