Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Nov 10, 2012, 11:38 AM
glidermang is offline
Find More Posts by glidermang
Registered User
boris:

It's not very much - about 2-3mm on most of my airplanes. Some need more, some need less. You should be looking for a nearly vertical climb, after release.

Yours, Greg
Sign up now
to remove ads between posts
Old Nov 10, 2012, 12:36 PM
vigli is online now
Find More Posts by vigli
Registered User
Thanks Greg.
Don't need flapperon down as a preset?
Only elevator?
correct?
Thx
Old Nov 10, 2012, 01:40 PM
cptsnoopy is online now
Find More Posts by cptsnoopy
Where is the lift?
cptsnoopy's Avatar
Hi Boris,

I use both a little up elevator and a little flap but this is optional. You don't need to use flap if you don't want to.

Charlie
Old Nov 10, 2012, 01:48 PM
glidermang is offline
Find More Posts by glidermang
Registered User
boris:

What Charlie says: only elevator.

I have one airplane (my Legend) where I use a small bit of up flap. But my Blasters (and I tired various combinations) work best with elevator only on the preset.

Keep in mind the behavior you are looking for: swing level on launch, have the airplane rotate to the climb attitude immediately after release, and continue straight after the preset is released. I release the preset at the same instant I release the airplane.

Yours, Greg
Old Nov 10, 2012, 02:19 PM
vigli is online now
Find More Posts by vigli
Registered User
Thanks a lot!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Heklp..! Futaba 10c Launch preset Mykro Radios 9 May 14, 2012 05:37 PM
Question Hitec Eclipse DLG launch presets? johngo Hand Launch 10 Nov 24, 2004 12:36 AM
Adding Elevator Launch Preset to JR631 marctrudeau Hand Launch 1 Apr 10, 2003 10:48 AM