Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Oct 03, 2012, 05:01 PM
momofx is offline
Find More Posts by momofx
Registered User
Discussion

KK2.0 and HK Blueseries ESC Calibration


Having trouble knowing what beeps to look out for when calibrating my KK2.0 to the hobbkying blueseries escs. Does anyone know what it should sound like when its time to put the throttle to mimimum??
Sign up now
to remove ads between posts
Old Oct 03, 2012, 06:43 PM
2Doggs is online now
Find More Posts by 2Doggs
Airborne
2Doggs's Avatar
I have a 40A Blue Series, and I recall that the tones I heard didn't exactly match the pdf manual. It's a while since I used it, but I would just wait for the first series of tones to end, maybe 3 - 5 seconds after plugging in before pulling the collective stick down. If you wait too long, it will go on to programming mode for all the other parameters in which case it's easy enough to pull the power and try again.

Good luck!
Old Oct 04, 2012, 02:11 AM
CH33ZEBURG3R is offline
Find More Posts by CH33ZEBURG3R
Registered User
I had the same problem, if you don't know what beeps they make then how are you supposed to do it correctly. I ended up doing them one by one without the KK2, it's very easy just have one esc going to the power and plug it into the throttle on your receiver, throttle up on your TX connect the esc to the battery (PDB) and as soon as you hear Two beeps throttle down then you'll hear a single beep and its done. Then do the next one.
Old Oct 04, 2012, 02:59 AM
momofx is offline
Find More Posts by momofx
Registered User
Quote:
Originally Posted by CH33ZEBURG3R View Post
I had the same problem, if you don't know what beeps they make then how are you supposed to do it correctly. I ended up doing them one by one without the KK2, it's very easy just have one esc going to the power and plug it into the throttle on your receiver, throttle up on your TX connect the esc to the battery (PDB) and as soon as you hear Two beeps throttle down then you'll hear a single beep and its done. Then do the next one.
Thanks man - I think I will do it that way again


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Mini-HowTo HK 30A BlueSeries ESC schematic and I2C/TWI mod [TwisteR] DIY Electronics 29 Sep 25, 2013 09:44 AM
Discussion Hot ESC without doing nothing - HK blueseries alfapistola Multirotor Talk 6 Jul 06, 2013 05:40 AM
Sold RC-Carbon Y6 W/ Avroto motors, HK BlueSeries Esc's Blucross Aircraft - Electric - Multirotor (FS/W) 1 Jul 25, 2012 06:55 PM
Help! Throttle calibration problem of Hobbyking Blueseries ESC 20A Aaqib124 Multirotor Talk 9 Jul 21, 2011 01:51 PM
Help! Throttle calibration problem of Hobbyking Blueseries ESC 20A Aaqib124 Power Systems 5 May 23, 2011 09:30 PM