Thread Tools
Old Oct 02, 2012, 01:11 PM
FlyingW is offline
Find More Posts by FlyingW
Build more, websurf less
FlyingW's Avatar
Question

Advice on working with XDP


I needed to run the XDP program to change the channel mapping on some nano receivers. I had a perceived problem where I thought the XDP program could not see the XDP device.

I have Windows 7. Installed the latest program from XPS (as Administrator) and the drivers installed successfully. Even tried a new usb cable.

Turns out the XDP program was looking for the actual receiver - not the XDP device! It works just fine.

I felt a little foolish, but was relieved to be able to make progress on the project.

Paul
Last edited by FlyingW; Oct 03, 2012 at 08:54 AM. Reason: continuing education
Sign up now
to remove ads between posts
Old Oct 02, 2012, 03:31 PM
FlyingW is offline
Find More Posts by FlyingW
Build more, websurf less
FlyingW's Avatar
Got it working as described above.
Last edited by FlyingW; Oct 03, 2012 at 08:54 AM.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Help. Cannot get started with Flamewheel and DJI alan2 Multirotor Electronics 8 Sep 05, 2012 07:52 PM
Discussion APM2.0 AUTO RETURN HOME SUCCESS! But cannot get position hold. OPEN MY PIDs. votreami Multirotor Talk 2 Jun 08, 2012 07:04 AM
Help! Cannot get gyro to hold the tail radarman Large Electric Helis 0 May 05, 2012 03:37 PM
Discussion Cannot get 12v DC output from Delta DPS-700EB brightfan Batteries and Chargers 5 Apr 01, 2012 01:06 AM
Sold xtremelink device programmer (xdp) 4*60 Aircraft - General - Radio Equipment (FS/W) 2 Apr 18, 2010 03:01 PM