Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Sep 30, 2012, 12:23 AM
prodriverex is offline
Find More Posts by prodriverex
The Engineer
prodriverex's Avatar
Discussion

How and what ESC settings do you put on yours?


Brakes, ON or OFF?
Switching Freq? 8 or 16kHz? My Turnigy Trust 55A has this but i never seen this in other ESC.
Sign up now
to remove ads between posts
Old Sep 30, 2012, 01:31 PM
Steveis is offline
Find More Posts by Steveis
AVR Dude
Brake off
NiMH battery
16kHz
Start mode normal
Cut off soft
Old Sep 30, 2012, 02:53 PM
NtiT is offline
Find More Posts by NtiT
Registered User
I set my switching freq. to high (22-30) and it works well.
Old Sep 30, 2012, 05:42 PM
dutchcommando is offline
Find More Posts by dutchcommando
making crashing a lifestyle!
dutchcommando's Avatar
the list as Stevis said..

but nowadays i just flash them to simonK firmware when i get them..
nothing more to do anymore with settings.. just throttle cali and use and abuse!
Old Sep 30, 2012, 07:32 PM
2400RDR is offline
Find More Posts by 2400RDR
Out of helis, sanity returning
I flash mine with SimonK too. No muss no fuss. They work better for multirotors too when flashed.
Old Sep 30, 2012, 07:53 PM
prodriverex is offline
Find More Posts by prodriverex
The Engineer
prodriverex's Avatar
Not all can flash.. at least my Trust 55 is not on the list.. I forgot to take a look at the circuit when I remove one of the shrink. Now that I put it back with bullets soldered, I dun have a bigger shrink to pass through that size now if I cut open.

There is this timing setting: auto, 7deg for multi poles motor, and 30deg for out runner! My motor is both multi and OR! I opt for 7deg since its a disc shape with 24poles.

Yes freq I choose 16khz.
Old Sep 30, 2012, 09:50 PM
NtiT is offline
Find More Posts by NtiT
Registered User
7 is for in runners, with usually less than 5 poles. 30 is for more poles, like almost all outrunners. Choose 30 definately for a motor with 24 poles.
Old Sep 30, 2012, 10:28 PM
prodriverex is offline
Find More Posts by prodriverex
The Engineer
prodriverex's Avatar
Ok will switch to that.
Just another elementary question on the Tx. I know this is a multi rotor heli setup, but we have to chose Acro mode as model type?
Old Sep 30, 2012, 11:33 PM
NtiT is offline
Find More Posts by NtiT
Registered User
Yep. The FC uses normal THR/RUD/AIL/ELE input instead of anything pre-mixed for helicopters.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion How do you workout what Kv motor for your hull hp88 Racing Boats - Electric 16 May 27, 2012 09:50 PM
Discussion how much line do you store on your winch webdragon Thermal 17 Apr 21, 2012 08:40 PM
Question Where do you get your trim designs and how do you test them? dedStik The Builders Workshop 16 Mar 15, 2012 04:32 PM
Discussion How do you set up DR/expo on realflight 6? Dr.JJ Simulators 7 Feb 23, 2012 06:20 AM