Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Sep 23, 2012, 08:10 PM
mass flyer is offline
Find More Posts by mass flyer
I Am a Proud Registered User


hey im going to do a project but need to kow what holds the alllireons and elevator to the foam where you cut it out
Sign up now
to remove ads between posts
Old Sep 23, 2012, 11:23 PM
jackerbes is offline
Find More Posts by jackerbes
jackerbes's Avatar
For flat sheet foam you can use strips of clear package sealing tape, that is about 2 mil tape (0.002") and would be like the Duck brand Standard (not Heavy Duty) tape you can get at Wal-Mart.

The attached figure shows how you use it, practice on some scrap and it won't take long to figure it out. The hinges will last as long at least as long as the airplane does!

Old Sep 24, 2012, 09:04 AM
zeroback is offline
Find More Posts by zeroback
Suspended Account
If using solvent safe foam Welders glue can be used to make a glue hinge.
In the first aid section of the drug store is a product called paper tape. I think it is Tyvek with a special human safe adhesive that sticks to oily skin. It is very sticky and strong. It's best quality is it is very flexible/limp compared to packing tape. It takes the corners with out the tendencie to straighten back out and lift at sharp bends.
Although I don't know how you equate hinging to electric motor repair but that's my suggestion
Old Sep 30, 2012, 03:47 PM
mass flyer is offline
Find More Posts by mass flyer
I Am a Proud Registered User
thx guys

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Dyna jet project. (Project X) Sneak Peek mulikow Fuel Plane Talk 4 Sep 18, 2012 11:37 PM
Discussion How a T-Rex 600e Pro went from a scale project to an FPV project Mike_Then Scale Helicopters 3 Jun 20, 2012 11:01 AM
Discussion Father/Son Project changed to family project... ApachePilot Mini Helis 71 Dec 21, 2006 10:09 PM