Low-wing Q500; dihedral? And how to laminate / sheet? - Page 2 - RC Groups
Thread Tools
Sep 16, 2012, 02:02 PM
Registered User
Beautiful plane, can you share plans with me? What wingspan / airfoil / motor / etc? I really like the tail construction, my design is seriously flawed, there. But mine is only a prototype, there is room for improvement there!


Sign up now
to remove ads between posts
Sep 16, 2012, 03:56 PM
Registered User
BTW, my fuse is now 338 grams, all done incl. covering, landing gear, pushrods and linkages. All to add is RX (9g), servo (18 g), ESC (?), motor and batterie pack.

Sep 16, 2012, 05:31 PM
Registered User
because this model is 1.30 1mtr of fuselage and wing for a motor 40, such JETT, NELSON, DKT, MVVS, all these quickie is to go, if you want something more average for any 40 you better, or equivalent in Brussles.
I think the profile is a MH17.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Do ships with a Spider 2.5 wing type dihedral roll ok -or annoying? kewhite Slope 18 Jun 21, 2012 11:09 PM
Discussion flying flat-wing (low dihedral) aileron planes rafe_b Beginner Training Area (Aircraft-Electric) 8 Jan 21, 2009 10:32 PM
FS. Q500 RTF, Q500 RTC, Kaos 40 wing, Falcon or Skylark 56 wing, other wing. harikay Aircraft - Fuel - Airplanes (FS/W) 14 Jan 25, 2005 07:46 PM
low wing with dihedral kit newbee E-flier Parkflyers 4 Oct 27, 2002 02:42 AM
Low Wing Dihedral? Barto Power Systems 6 Jul 03, 2001 10:31 AM