1/10 Scale LED Police Light Bar
This LED light bar is the perfect addition to your law enforcement or emergency scale vehicle. The dimensions are sized to fit perfectly on a 1/10 scale body. It features 16 total LED mounted on a chip board controlled by 2 momentary switches. One switch controls the 4 red and 4 blue LED on the front panel, while the other switch controls the 8 amber LED on the rear. The switches also provide the choice of 9 different flash modes allowing different strobing patterns and effects. This bar will be the perfect finish on any RC or scale model.
Wire Harness with Power Switch
2 Momentary switches
9 Flash modes
16 Total LED
12volt D.C. Input
16 LED light bar
Plastic Silver Housing
2 Momentary Switches
9volt battery clip
Mounting bolts, washers, and nuts
*Clip connectors are pre-soldered
*The light will run on 3-12volts. Hook up a battery or power them directly from your receiver.
*LED brightness will depend on the voltage supplied.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||3Racing LED Light System For 1/10 Scale||queadlunnrau||Cars - Cars and Parts (FS/W)||1||Nov 12, 2011 12:25 PM|
|Help!||police light bar||nitro22||On-road Cars||2||Feb 19, 2010 05:07 PM|
|Discussion||Looking for Police LED lights like this, does anyone know of a source?||TDboy||Electric Heli Talk||1||Aug 05, 2007 09:00 PM|
|Discussion||1/10 (or 1/8) scale police car||visionviper||Car Talk||0||Apr 10, 2007 01:00 AM|