Art-Tech P-51D Mustang 500 class gap and collet issue
I have an issue with the 1mm gap that is supposed to be between the back of the spinner and the fuselage. My gap is much larger than that. See attached pictures. It seems the collet is too short for this motor shaft. What can be done to shorten the gap?
I also have an issue with the collet that came with the plane. There is not a way to lock\hold the collet from spinning the motor shaft when tightening the propeller nut. When I try to tighten the propeller nut onto the collet the collet spins the motor shaft and I am unable to tighten the nut.
A wrench came with the plane and I am not sure what it would be used for. It seems to me that if the collet had a flat\slotted area on it the wrench could be used to fit in the 1mm gap to keep the collet from spinning the motor shaft during tightening. Let me know what you think.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Art Tech 500 Class P-51 sound module not working.||seadog985||Banana Hobby||4||Jun 20, 2012 02:38 PM|
|Discussion||Art tech Cessna 182-500 class Landing light issue||maris_ata||Electric Plane Talk||1||Feb 02, 2012 10:11 PM|
|Discussion||Art Tech Cessna 182 500 Class build issues||angry_muppet||Beginner Training Area (Aircraft-Electric)||4||Oct 12, 2011 02:30 PM|
|Video||Art-Tech P-51D Mustang||funfly2||Electric Plane Talk||3||Jul 19, 2008 07:06 PM|
|Video||Art-Tech P-51D Mustang||funfly2||Electric Heli Talk||0||Jun 28, 2008 02:19 PM|