|
|
Thread OP
|
Question
HB UG's - LiPo, Motors - Questions
I have a HB on the way with 2c LiPo batteries, swash ball u/g,
head stffener. Went with CC pixie7 & GWS 100ICS to start 1st planned u/g - GWS DD tail drive 2nd - Acro 280BB or equiv. 3rd - Astro 10T BL w/ CC PH-10 ESC Questions: -Can the BL motor run on 2C LiPo 7.4V (E-Tec 1200's) OK? -Do I need a 3cell pack instead? -Will a 3cell pack kill the DD tail motor? Thanks! |
|
|
|
|
|
|
Sounds like you have been doing some research.
From what I understand the answer to your BL 3 cel 2 cell question depends on which Brushless motor you go with. I have a Razor V2 9T pinion which performs great on a 2 cell E-tech Li-poly pack, but from what I have heard about other brushless motors the Astro 10 brushless need 3 cells to get out of ground effect. By the way how is the flying in Cochrane lately? |
|
Last edited by Randall; Nov 24, 2003 at 04:49 PM.
|
|
|
|
Why the Pinion Change?
Wahat do you gain by increasng the pinion from 10-12 for the hornet blades?
Unfortuanetly, I broke my hornet blade at the base as expected the first 30 seconds I tried em. It did look like the head speed was higher, so I wonder about the amp draw vs the stock setup(300 motor with 10 tooth(not stock , I guess) Stuka |
|
|
|
|
Thread OP
|
Thanks for the info,
Still one outstanding question though, When you go to 3cell LiPo's at 11V, what do you do with the tail drive motor? Can the replacement OEM or replacement DD take it (6V)? |
|
|