Blade nano CPX - even smaller than the mCPX! - Page 94 - RC Groups
Thread Tools
Oct 14, 2012, 12:50 AM
Can't get enough
jabsten's Avatar

Short 2 min video


I am flying my stock nano with stock lipo. Very stable and awesome for indoor 3D. I have 2 and go back to back. Thank you HH!

Bland nano (1 min 51 sec)


J
Sign up now
to remove ads between posts
Oct 14, 2012, 02:06 AM
Registered User
How comparable is the difficulty of flying the nCP X vs that of the Ladybird? I'm especially interested in indoor flight.

Thanks
Last edited by Zoide; Oct 14, 2012 at 02:16 AM.
Oct 14, 2012, 03:04 AM
RC addict? I'm not addicted...
Nighthawk74's Avatar
Did you use hot melt? I have never had a HG joint come off[/QUOTE]

No I just grabbed the little kiddie safe HG gun, my son uses. It was on hand. Mine is harder to get at. Must find the time to clean out the basement...sometime.
Oct 14, 2012, 07:05 AM
It flies!!! ... so who cares ?
erdnuckel2's Avatar
Quote:
Originally Posted by Zoide
How comparable is the difficulty of flying the nCP X vs that of the Ladybird? I'm especially interested in indoor flight.

Thanks
I would say it is a very kind of flying ... not sure if it even should be compared. As far as flying a CP heli however, it is probably the best idea you can have to learn it ...
Latest blog entry: Random Pictures ...
Oct 14, 2012, 07:15 AM
Registered User
cfossa's Avatar
Quote:
Originally Posted by indoorheli
I can flip the nano in my shower and even a little bit under a table..had to try

The mcpx Smallest area I could go was my bathroom.

The nano I can run into anything without worrying about damage.

So yes IMHO if you have a mcpx the nano is still well worth it but skill dependent you might have to still practice a bit with a pretend ceiling outside before flipping inside
Thanks! Sound like exactly what I "need" over the winter

Carl
Oct 14, 2012, 07:16 AM
Registered User
cfossa's Avatar
Quote:
Originally Posted by Matt Ls Thumbs
Yes, it is that different. You can fly it indoors with a bit of practice. I do recommend outside first.

A few weeks with the Nano will help your mCPX skills too.
Thanks!

Carl
Oct 14, 2012, 07:48 AM
Registered User
TurboCinqy's Avatar
Just installed Phoenix on my notebook.
Probably better for my nano to get more basics.
always hate the phoenix after a few minutes but it's the cheapest way to memorize stick inputs.

btw Why the didn't deliver a 230V supply for the charger.
Thought the Walkera 4#3 had the same connector but it didn't After about 15 charges the AAA batt died.
Tried to find a 6V adaptor but the one I had was nog stabilized and Almost thought I blew up my charger DMM gaved met 18Volts without load.
Centerhole was a bit bigger so probably I even didn't make contact with it.

Now it had rechargeable batteries. in it and I think it works.
Oct 14, 2012, 08:05 AM
Registered User
Quote:
Originally Posted by Zoide
How comparable is the difficulty of flying the nCP X vs that of the Ladybird? I'm especially interested in indoor flight.

Thanks
I don't think a cp heli can be compared to a quad. The quad is wayyy more stable. The only thing it may help prepare you for is orientation. However, the nano is probably the best and most crash resistant cp if you are just starting out.
Oct 14, 2012, 08:19 AM
Don't tell me, I overdid it.
Number1BSArtist's Avatar
Man this thing is maybe a bit too awesome. It's definitely letting me get sloppy.

Tonight I had quite a few sessions of going crazy trying to even out the thrust by adjusting my pitch trim and then going nuts further by adjusting my pitch travel.

Much later, I finally noticed that I had broken the swash and the right arm was just hanging by a couple of strands of plastic. Still flew, upright/inverted, pitch pumps etc. until I noticed and replaced.

Just a reminder to check your stuff.
Oct 14, 2012, 10:15 AM
Registered User
Last time I emailed HH about a bad motor for my MQX they told me that there is no warranty on little brushed motors, so I ordered V929 motors to replace it with. They are cheap, well, not the Blade ones.

Anyway, I HAVE A QUESTION, I have my Nano ordered but need a charge cable. What kind of battery does this take? I have multi charge cable for 1 3.7 mini eflight connector like used in the UMX 1S planes. Does this use a different connector? Is this what I need?

http://www.hobbyking.com/hobbyking/s...dProduct=18867

It says for Mcpx but I always thought mcpx uses same tiny 1S connector as on UMX planes
Oct 14, 2012, 10:36 AM
Registered User
rcflyair's Avatar
The mcpx connector looks the same, but its just a little bigger than the ones for 1S UMX planes.......
Oct 14, 2012, 10:46 AM
Registered User
OK, I how about the nano connector, same as mcpx? have charge cords for the tiny umx planes AND the above one on order.


Thanks for the info!
Last edited by shahram72; Oct 14, 2012 at 11:15 AM.
Oct 14, 2012, 10:49 AM
Registered User
rcflyair's Avatar
Ooops sorry. The nano cpx uses the smaller connector just like on the smaller one on UMX planes and the msrx...
Oct 14, 2012, 11:34 AM
Registered User
Quote:
Originally Posted by shahram72
Last time I emailed HH about a bad motor for my MQX they told me that there is no warranty on little brushed motors, so I ordered V929 motors to replace it with. They are cheap, well, not the Blade ones.

Anyway, I HAVE A QUESTION, I have my Nano ordered but need a charge cable. What kind of battery does this take? I have multi charge cable for 1 3.7 mini eflight connector like used in the UMX 1S planes. Does this use a different connector? Is this what I need?

http://www.hobbyking.com/hobbyking/s...dProduct=18867

It says for Mcpx but I always thought mcpx uses same tiny 1S connector as on UMX planes
I got one of these and really like it. It will do ncpx and mcpx batteries.
http://epbuddy.com/index.php?main_pa...roducts_id=347
Oct 14, 2012, 11:50 AM
Registered User
JLink125's Avatar
Not sure if you can use this but here is the charge lead I made so that I could use my normal Lipo charger. All I did was simply open up the stock charger that comes with the Nano and remove the connector by clipping the wires at the board and soldering a deans ultra plug to the other end, really easy, the only down side is that I can't charge multiple packs at once but hey it's far better then the stock charger.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Cool Walkera MiNi CP - Smallest 100 sized 3D helicopter zadaw Micro Helis 6166 Nov 20, 2016 12:57 AM
Discussion is there anything better than mcpx v2 at same or smaller size? Legendary_Agent 3D Electric Heli Flying 33 Feb 24, 2012 09:46 PM
Question Whatís Better than a Blade CP and Smaller than a Trex? HavingFun2002 Micro Helis 74 Mar 05, 2006 06:07 PM