New to programmable TX's Futaba 9C - RC Groups
Thread Tools
Aug 22, 2012, 02:15 AM
Common Sense Support Crew

New to programmable TX's Futaba 9C

I have a Futaba 9C TX. The rudder and ailerons only work in 1 direction. Going to the servo screen I only get movement to the left it doesn't come off neutral with the stick to the right. On servo 4 I get nothing in either direction. I set the profile to factory settings. I am using a Frsky 2.4 DFT module. I have tried the Spectrum DSM2 with the same result. Putting the original 72mhz module in gives the same result. If I turn test ON everything seems to cycle fine. Could I have made a setup error when trying to reset to factory defaults?

Sign up now
to remove ads between posts
Aug 22, 2012, 06:02 AM
Oxford Panic
AndyOne's Avatar
Each model memory needs to be reset individually, did you reset one memory and then use another which hadn't been reset.

Aug 22, 2012, 09:41 AM
Common Sense Support Crew


Tried that and everything is working fine now.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Futaba 9c with FrSky Tx modual & FrSky 7ch Rx TBello Aircraft - General - Radio Equipment (FS/W) 2 Aug 06, 2012 12:34 AM
Sold )))NEW $225.00 shipped((( Futaba's new 8JH TX & RX NIB crosby Aircraft - General - Radio Equipment (FS/W) 7 Aug 03, 2012 11:13 AM
Wanted Futaba 9C ch 52 tx Module bvrcgeoff Aircraft - General - Radio Equipment (FS/W) 1 Jul 18, 2012 07:11 PM
Off Site Like new Futaba 8JH 2.4 GHz TX and RX S-FHSS/FHSS crosby Aircraft - General - Radio Equipment (FS/W) 4 Jul 07, 2012 04:53 PM
Multiplex Evo's vs Hitec Eclipse 7 or Optic 6 vs Futaba 9C /Super 9C or any other Tx' pjm21b Radios 1 Oct 14, 2004 11:08 PM