Made a few steps forward - RC Groups
Thread Tools
This thread is privately moderated by cwg25, who may elect to delete unwanted replies.
Aug 17, 2012, 07:33 PM
You Enjoy Myself

Made a few steps forward

I had a friend help me with soldering and learned the solder I was using wasn't good, even though it was 60/40 rosin.

We tried another brand and it worked fine. I'm able to solder now and attached the deans connector wire to the board and the wires for the receiver.

I was able to connect just about all the wires to the naza and receiever. There are two wires from the on/off switch I'm not sure where to attach, if I even need to. I see one of these can fit in the receiver or naza unit. The second I'm not sure where it goes. The third is attached to the data port on the receiver, I know that goes there.

I've stopped short of attaching the GPS unit. And I haven't affixed the naza unit, reciever, or LED unit to the plate yet. Zip ties hold down the ESCs.

Any comments, suggestions, or constructive criticism would be appreciated.
Last edited by cwg25; Aug 18, 2012 at 10:40 AM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale pair of custom-made forward-neutral-reverse transmissions made by mr kanello to suit aspire2008 Boats (FS/W) 0 Nov 08, 2008 04:24 AM
Discussion A few guys in the marine boats enviorement also made a few home brew 12volt versions treehog Batteries and Chargers 0 Mar 20, 2007 09:33 AM