Can I run my KK2 board & ESC's off my Bench Power Supply? - Page 2 - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Aug 16, 2012, 05:21 AM
Registered User
Quote:
Originally Posted by TS00
Nah, it'll be fine, you'll never pull hundreds of Watts on the bench, there's nowhere for the power to go.
It goes to the propellers as a rule.

But without knowing the motors and props being used, we are just guessing.
Sign up now
to remove ads between posts
Aug 16, 2012, 08:58 AM
Emress
motors w/o props and youd bee fine as no load current is really low.
Aug 16, 2012, 11:16 AM
we dont NEED roads!
AcroFPV's Avatar
Motors are DT750's and props are 10x4.7

I would most likely balance the motor without a prop, then balance the prop on the motor afterwards.
Aug 16, 2012, 01:44 PM
Emress
you can run one dt750 at a time on that psu and that prop


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold (UPDATED)3 esc's with power board+flight control board and programer ALL SPLIT UP dr rc Aircraft - Electric - Multirotor (FS/W) 2 Jul 07, 2012 10:18 PM
Question Can I run a 12v power supply instead of a battery in my radio for simulator usage? super_nova Radios 11 Apr 27, 2009 07:13 PM
Discussion Can I run two chargers off 12v power supply? bhoges17 Electric Plane Talk 5 Dec 30, 2008 03:16 PM
Can I run Two Chargers off of (1) 12V regulated power supply? mrebman Batteries and Chargers 4 Feb 28, 2005 04:58 PM