Thread Tools
Old Aug 12, 2012, 02:16 AM
feradi is offline
Find More Posts by feradi
Registered User

Frsky FLD-02, A1 value help...

Hi Guys,

I'm a little bit confused here and I need your help. I do have:

Frsky FLD-02 with soft 2.1
Frsky FBVS-01 sensor
Frsky DJT Module
Trying to put everything together with 4 cell 14.8 LiPo.

A1 - Jumper from x to A1
A2 - Cable from FBVS-01, I cut the ground

A1 - Volt Ratio 4
A2 - Volt Ratio 6

FLD-02 Values:
A1 (Left Value) - 5.2
A2 (Right Value) - 15.9

I know A2 looks right, but what is A1? What is that A1value telling me?

Thanks a lot
Sign up now
to remove ads between posts
Old Aug 12, 2012, 02:43 AM
davx is offline
Find More Posts by davx
Registered User

The A1 value tells you the voltage supplied to you receiver (cause you're using the jumper) and I guess this is a ESC bec with a quite common 5.2v (mine is same).

You should read the receiver manual, even if it's not easy, there is good informations about features...

Old Aug 12, 2012, 03:01 PM
renatoa is offline
Find More Posts by renatoa
Registered User
Yes, when A1 is jumpered, it measures internal receiver voltage (BEC)
If you need to measure two separate external voltages, for example a second pack, remove the jumper and install a second FBVS-01 sensor, setting the ratio accordingly.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question FrSky FLD-02 Reset/Alarms Tabasco Radios 19 Aug 31, 2015 11:14 PM
Help! FrySky FLD-02 Telemetry -- Help programming alarms Edwinzea Radios 12 Apr 11, 2014 01:41 AM
Discussion Help for Multiwii MAG orientation value monkey1 Multirotor Talk 0 Apr 13, 2012 03:06 PM
Sold Frsky FLD-02 and FBVS01 Mrbowtie26 Aircraft - General - Radio Equipment (FS/W) 0 Mar 08, 2012 07:49 PM
Discussion Help: arduino ppm values to th9x slave rcpilotp51 DIY Electronics 6 Mar 04, 2012 06:13 AM