Thread Tools
Old Aug 02, 2012, 10:00 AM
wc_wickedclown is offline
Find More Posts by wc_wickedclown
Registered User
Discussion

what could cause the tail to blow out when flipping the heli


does not blow out when doing punchouts

im thinking it could be to much rudder expo using 15 percent atm
Sign up now
to remove ads between posts
Old Aug 02, 2012, 10:14 AM
ridge_racer is offline
Find More Posts by ridge_racer
Registered User
What is your setup? It could be a few things? Are you sure you are not inputting a little rudder during the flip?
Old Aug 02, 2012, 10:30 AM
wc_wickedclown is offline
Find More Posts by wc_wickedclown
Registered User
Quote:
Originally Posted by ridge_racer View Post
What is your setup? It could be a few things? Are you sure you are not inputting a little rudder during the flip?
spartan gyro on both birds
seems when i use low head speeds is when it kicks the most and im kind of sure its not me giving that much input
Old Aug 02, 2012, 05:26 PM
Alan Hahn is offline
Find More Posts by Alan Hahn
Registered User
Low headspeed makes it hard for the gyro to have enough tail authority (=thrust). Now depending on your throttle curve, and whether your pitch curve is really symmetric about midstick, , it is also possible that inverted is flying with even less headspeed.

That could cause the blowout to be worse on the flip.

I say first thing to try is higher headspeed.
Old Aug 03, 2012, 11:42 AM
wc_wickedclown is offline
Find More Posts by wc_wickedclown
Registered User
i think i figured it out

i use a separate gyro gain per idle up condition unfortunately i use 35 percent for all three conditions i noticed in idle 2 the tail does not blow out when doing flips


my crashes have been in idle 1 so i guess i may need to increase the gain to 40 percent in idle 1

lesson learned and only cost me 300 bucks to learn lol
Old Aug 07, 2012, 04:19 AM
ridge_racer is offline
Find More Posts by ridge_racer
Registered User
That much damage from a tail blow out??
Old Aug 08, 2012, 02:53 PM
wc_wickedclown is offline
Find More Posts by wc_wickedclown
Registered User
Quote:
Originally Posted by ridge_racer View Post
That much damage from a tail blow out??
i was lower to the ground when i flipped it then i should have been
blades boom .
servos and motor are ok so i feel lucky

ordered the new design sab blades 45 bucks they are 55 to 70 bucks everywhere else.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 5 blade head tail blows out. mikes68charger Multirotor Talk 1 Jun 30, 2012 12:02 AM
Discussion what could cause a belt to get lose and what can i do wc_wickedclown Electric Heli Talk 6 Jun 23, 2012 04:01 AM
Discussion what could cause my align esc not to make the arming beep. wc_wickedclown Electric Heli Talk 14 May 23, 2012 11:27 AM
Discussion What could cause my R50 tail to not hold when hard climbing? Vertical Electric Heli Talk 16 Jun 18, 2006 08:38 AM
Help! What could cause my foam sheets to "warp" when slicing them? NetForce2K Foamies (Kits) 18 Jan 28, 2004 05:31 PM