|
|
|
What an easy build! The airplane is built, painted and ready for decals and the test flight. I used the AS3X system out of a wrecked UMX Mig-15 and cut out some ailerons. The test glide in the living room went well. Now for the wind to quit to I can see how overpowered it is with the sub micro Turnigy motor out of a little Edge 540 and a 2S 180 mAh battery
|
|
|
|
|
||
|
Quote:
Bert |
|
Latest blog entry: Customer Support Forum
|
||
|
|
|
I love it! It looks perfect!
|
|
|
|
|
|
I need the wind to quit so I can really open it up but the first test flights are nice and stable! I kept it cheap by using the RX/TX from a $20 Hobbyking Extra 300 and a motor from a wrecked e-flite micro heli
|
|
|
|
|
|
Hey guys. I have an ember 2 which I don't know if I want to rebuild, or put the electronics into this. Has anyone modded this to be able to use the ember 2 motor?
|
|
|
|
|
|
So I've got the Extra 300 and the extra 300 uses a N60 2S powered motor, are you using the motor from the plane or a normal pager motor of 3.7V what are you doing about the voltage difference?
|
|
|
|
|
|
|
|
|
|
|
|
I would really like to see a Yak board up close, I realised the only difference between the boards of the SkyEagle and E300 are a blob of solder bridging the "SW" pads and the Aileron setvo connector, I bypassed the 5V regulator on one of them boards and was able to run the servos just fine on 1S but the motor would not fire, if I can find a way around this I could use a modded 2S board for one of these.
|
|
|
|
|
|
Hey DF, any news on the retracts?
|
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
New Product | ***NEW*** ACIES6400 Micro pusher jet by:DYNAMIC FOAMY | DynamicFoamy | Scratchbuilt Indoor and Micro Models | 118 | Aug 27, 2013 09:29 PM |
Question | Foamie Airliners | Nate95 | Electric Plane Talk | 4 | Jul 04, 2012 10:37 AM |
New Product | ******NEW YAK-55 Micro by DYNAMIC FOAMY******* | DynamicFoamy | Scratchbuilt Indoor and Micro Models | 47 | Mar 10, 2012 03:48 PM |