nano receiver will not bind - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Jul 24, 2012, 08:28 PM
Registered User

nano receiver will not bind

I have a 6 channel nano receiver that goes into reset everytime I power it up wether I have a binding plug installed or not. Always the same flashing slow flash then the light goes out
Sign up now
to remove ads between posts
Jul 24, 2012, 10:14 PM
↓↘→ + (punch)
theKM's Avatar
powering up with binding plug already connected puts it into "connect to a computer mode".

for binding, turn the receiver on first without the binding plug, then add the binding plug until the LED changes state, then remove... now you're in binding mode.
Jul 25, 2012, 01:23 AM
Stress Be Gone
GBR2's Avatar
Also see the sticky Binding your Xtremelink System
Jul 25, 2012, 12:32 PM
Is this with nothing connected to the B port at all? Sometimes a BEC plugged into the B port will cause this. If this is the case, remove the signal wire from the BEC.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Fs-t4a transmitter and hk-tr6a receiver not binding rcta15 Radios 1 Apr 15, 2012 03:50 AM
Discussion Proto Max will not bind?? discostu9 Micro Helis 13 Mar 04, 2012 02:04 AM
Discussion DX6i Will Not Bind johnorama Radios 0 Mar 01, 2009 09:43 PM
Help! DX7 will NOT bind magee8578 Radios 2 Oct 18, 2007 10:23 AM
Discussion DX6 will not Bind What the HECK? Madguns Radios 0 Aug 04, 2007 11:47 AM