Carbon Fiber Quad, Plush 30a, 2830 EMP, HK KK Dialed in, 3000mah, extra motors etc
Up for sale is my baby! This is x450 carbon fiber frame with a HK KK controller, 4x 30a plush controllers, custom wiring,4x EMP 2830 - 1100kv, and a Turnigy 3000mah 30c / 60c lipo battery.
I am also including a bunch manuals and extra parts I currently have including a whole set 4x of D2830-11 1000kv turnigy motors, bunch of prop adapters, extra props, extra carbon fiber tube (unilateral and cross pattern), USBasp AVR Programming Device for the KK device.
This quad can carry quite a load as configured, I did some testing and was lifting around 2.5lbs with decent flight characteristics. I did up to 4lbs but that was very tough to keep stable.
The KK board is dialed in and loaded with Xcopter 4.7. Currently fitted with 10x4.7 props.
I am selling this because I used this to spark my interest in aerial video but now need to have higher payload capacity and will be going to a higher rotor count unit from here. The one EMP motor sounds different from the rest but doesn't seem to be any more warm after flying I do included an extra emp motor that was basically new but lost a phase wire completely but could be used for its rotor, bearings, etc.
I am looking for $230 EDIT NOW $180 to your door, Paypal
No receiver or radio is included.
EDIT: PRICE DROPPED TO $180 shipped!
Last edited by magudaman; Jul 19, 2012 at 01:22 PM. Reason: PRICE DROP!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Rave||HK KK V2 Quad board (and other recent KK boards)||randall1959||Multirotor Electronics||2584||Aug 11, 2014 03:01 PM|
|Sold||Vairo Quad full carbon fiber frame, with esc's and motors.!! Updated!!!||tc3wins||Aircraft - Electric - Multirotor (FS/W)||2||Jul 05, 2012 07:25 PM|
|Sold||EMP C-2830 750 kv motor new in box (2)||pro bro steve||Aircraft - Electric - Power Systems (FS/W)||0||Jun 03, 2012 10:41 AM|
|Sold||Carbon fiber quad with red KK+ board RXR will sell seperatly.||tc3wins||Aircraft - Electric - Multirotor (FS/W)||3||Oct 28, 2011 12:49 PM|