DJI Wookong M - PID and Gain settings, Question - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Jul 18, 2012, 01:04 PM
Registered User
dp_matt's Avatar

DJI Wookong M - PID and Gain settings, Question


Im trying to figure out what would the best settings be for my y6. I have the basic gains setup at 100% across the board and its flying some what like a floppy disk. I did bump the basic gains to 130% P,R,Y and it was almost unflyable.

I can't find anything that talks about how the multi rotor flies compared to the gain settings.

From my experience it would seem like the gain is too low but when i bumped them up it was not controllable.

I am wondering if there are any videos or threads that talk about the settings and the best way to get as close to perfect as i can.

Thank you
Last edited by dp_matt; Jul 18, 2012 at 01:29 PM.
Sign up now
to remove ads between posts
Jul 18, 2012, 02:24 PM
Suspended Account
You should try putting the Basic and Atti gains on Pot on your transmitter. This way you can adjust them in the air.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion DX8 radio question with my DJI F550 NAZA, basic and Attitude gain settings. jasper7821 Multirotor Drone Talk 8 Dec 16, 2012 12:46 PM
Question fy31ap pid setting julie32 FPV Talk 0 Jul 06, 2012 09:42 AM
Discussion GAZ 126 gryo gain question Pete1232 Electric Heli Talk 11 Jun 27, 2012 01:42 AM
Question KK 4.7 Gain/Payload Question dannyguk Multirotor Drone Talk 2 Jun 25, 2012 10:20 AM
Discussion Interesting idea for setting gains/PIDs signal15 Multirotor Drone Talk 4 Jun 13, 2012 06:38 PM