Hk v3.0 multi rotor control board - RC Groups
Thread Tools
Jul 18, 2012, 07:39 AM
Registered User

Hk v3.0 multi rotor control board

Can any one tell me what firmware is on the Hk v3.0 multi rotor control board when you buy it thanks
Sign up now
to remove ads between posts
Jul 18, 2012, 07:59 AM
Registered User
Is there a way to reset this board
Jul 18, 2012, 10:39 AM
Registered User
Assuming HK v3.0 has the same firmware as v2 (now called v2.1), It is basically KK v4.5 quadcopter in "+" configuration. When I researched it a while back, members told me it was a simpler version of KK v4.5. This is all I know about what you are asking. I don't know if you can reset it or not.
Jul 18, 2012, 11:15 AM
Registered User
Just flash it with the firmware version you want, it resets the settings then.
Jul 18, 2012, 05:34 PM
Registered User
Ok thanks for your reply guys appreciate your help just having a few problems with my board thought I might be able to reset but I will try to flash it
Jul 18, 2012, 10:41 PM
Registered User
Thanks very much JackinFtLaud that is very helpful bit of information

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Mini-HowTo Arduino and HobbyKing Multi-Rotor Control Board V3.0 or KKmulticontroller v5.5 pprioverde Multirotor Drone Talk 33 May 28, 2017 12:40 PM
Discussion Hobbyking KK2.0 Multi-rotor LCD Flight Control Board MoRaLeSD Multirotor Drone Talk 5 Apr 09, 2014 12:05 PM
Discussion Schematic of "Hobbyking KK2.0 Multi-rotor LCD Flight Control Board" MHefny Multirotor Drone Electronics 60 Jun 29, 2013 01:45 AM
Help! Hobbyking multi-rotor control board v3.0 stanley367 Multirotor Drone Talk 3 Jul 25, 2012 05:31 AM
Question Quad Build Using HobbyKing Multi-Rotor Control Board V3.0 (Atmega328 PA) SJackson Multirotor Drone Talk 27 Apr 30, 2012 09:51 PM