cut half of one receiver antenna
Accidentally cut 1 of the antennas of the receiver in half (not sure how).
It is a Futaba RS617FS receiver.
I went to try the quad and it lift off and about 40cm from the air, it does a yaw move to the right and then accelerates like hell. .
It's hard to buy parts in Costa Rica, so I wonder if you know of a DIY method to replace these coax antennas?
Any suggestion on where to buy them if there is no DIY fix method?
I just built this quad, it works perfect, not like the old one and this happened. So sad. :P
I'm faily new with RC. Not this kind of spare parts yet.
I see that a DIY antenna will not be easy.
So I found this ones on ebay:
And bought a bunch of them just in case.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Using CNC router to cut curve wings top and bottom surface make halfs||videorov||Composites Fabrication||3||Apr 30, 2012 07:24 PM|
|Discussion||Using CNC router table to cut out half of fuselage and wings||videorov||Foamies (Scratchbuilt)||9||Apr 04, 2012 07:18 PM|
|Help!||Receiver antenna half broke :(||yorky||Electric Power Cars||9||Jan 20, 2009 07:59 PM|
|Discussion||Cut my antenna in half.....||shamrock1990||Beginner Training Area (Fuel)||14||Jun 11, 2008 06:18 PM|
|Help!||Receiver cut-off at half throttle||Tcko||Micro Helis||4||May 03, 2007 09:38 PM|