Custom Steel Tonka Body for FPV Summit - RC Groups
Thread Tools
This thread is privately moderated by healthyfatboy, who may elect to delete unwanted replies.
Jul 07, 2012, 11:28 PM
Trader Rating: 335
Registered User

Custom Steel Tonka Body for FPV Summit

I made this for my Summit to do FPV as a spare body but there's no need for me to have two. It's basically plug and play ready for your Summit to get it up and running without video gear. The camera housing was made for a GoPro HD Hero 2 but could easily be modified to fit the original HD Hero.
It fits in place of the stock body posts in the same location and is a quick change from the stock body if you want to go back and forth. Just be sure to add preload to the springs as this body is heavier than stock.
Save yourself the hassle of having to square out the holes for the body posts and doing all the cutting and trimming of the steel and plastic to make it fit just right over the Summit.

$100 shipped in the CONUS.

If you want the GI Joe that goes along with it, add another $20.
Last edited by healthyfatboy; Jul 08, 2012 at 07:34 AM.
Sign up now
to remove ads between posts
Jul 17, 2012, 06:00 PM
Trader Rating: 14
Registered User
SnarkyMcSnarkson's Avatar
What would have to be modified on the mount to make it work with a first generation GoPro?
Jul 17, 2012, 07:47 PM
Trader Rating: 335
Registered User
The cut for the AV out would need to be made in the box on the bottom half as opposed to the top half for the HD Hero 2.
PM Sent.
Jul 17, 2012, 11:11 PM
Trader Rating: 335
Registered User
Sold! Thanks RCG!

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Custom Tonka Body for FPV Summit healthyfatboy Cars - Trucks and Parts (FS/W) 5 Jul 07, 2012 11:26 PM
Sold FPV Tonka Summit healthyfatboy FPV Equipment (FS/W) 6 Jun 24, 2012 08:49 PM