Thread Tools
Jul 06, 2012, 06:16 PM
Registered User
Help!

Why does my blade mqx fly like s@#t?!


After several crashes and dorks, my blade mqx flies horribly! At hover or slow forward flight its fine. How ever,, at high throttle it wigs out, starts tik tocking, goes into a wicked cycle of over correction and then crashes.

Reason I am concerned is it takes high throttle to flip or roll the little bugger,, and as of now, al I got is about up to 2/3 throttle before it starts freaking out.
Sign up now
to remove ads between posts
Jul 06, 2012, 06:22 PM
Cranky old fart
Balr14's Avatar
Check your motors all spin freely with the same lack of resistance. Make sure all of your blades are tracking nicely, bend them if not. Check the gears. Try a fresh battery.
Jul 06, 2012, 08:21 PM
Registered User
After a few crashes, your motors and your props are not as evenly matched as they were when new. As a result, the mini-computer-brain on board the mQx has a much rougher time getting power levels correct at full throttle. When you go full throttle, let's say that one motor is giving the highest level of the four. The other three are close but not spot-on. That means the "high" motor is going to start to cause a flip. The gyro circuit on the mQx is going to try to compensate, but it over-corrects and you get what you've experienced. The above description is for one motor, but if you've got two that provide full power and two that don't, you can really have a handful.

After losing one somewhere in the neighborhood trees, my replacement was very nearly perfectly balanced. It still had some, as you put it, tick-tocking when I went full throttle. My lesson after another out-of-control flight termination from such behavior is no full throttle.
Jul 10, 2012, 02:45 AM
Registered User
gitit20's Avatar
Mine flies just fine only time i ever get what your talking about is at full throttle the fact is its not brush-less thus not as precise...

however check for twisting of the arms I once split mine down the side and it would twist and cause it to go one direction or the other but not as bad as you described They will twist a bit but should not be very easy to do so more then 1/8 turn if you can get more twist and its easy to do so then you prob should replace you arm. its easy and parts are cheap all over ebay
Jul 18, 2012, 03:51 PM
Registered User
Alright,, so i replaced all 4 props and its flying much better. I think 1 or 2 of the arms are cracked though. CA did not fix them, and they do twist just a bit more than the other 2 arms.
Jul 19, 2012, 12:28 AM
Registered User
I just want to know what you did to get it to tick-tock. That would be awesome!!
Jul 19, 2012, 02:16 AM
Registered User
It was like a reverse tick tock as if the fulcrum were above and the arcing path of the heli was below. It would swing side to swaying and rocking. All I had to do was give full throttle and it would do it. Now with all 4 new props its much better. But the aftermarket body its got has thrown off the balance.
Jul 29, 2012, 11:21 AM
Registered User
Well, I crashed the s#$t out of it again.
Jul 29, 2012, 11:26 AM
Ape-pilot Extraordinaire
TS00's Avatar
Quote:
Originally Posted by topforce View Post
Well, I crashed the s#$t out of it again.
If you don't crash once in a while, you're not flying hard enough
Jul 30, 2012, 12:25 AM
Registered User
gitit20's Avatar
Oh ya haha my poor MQX had been to hell and back...



Quote:
Originally Posted by TS00 View Post
If you don't crash once in a while, you're not flying hard enough


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! CRASHED my DJI F550 Hexacopter, don't know why. broke a blade but why? jasper7821 Multirotor Talk 26 Jul 11, 2013 01:52 PM
Discussion Why I didn't fly today! ?? Kimber Electric Plane Talk 71 Jul 01, 2012 08:39 AM
Discussion Why Does My Plane Need So Much Uptrim? krexken Electric Plane Talk 18 Jun 30, 2012 05:35 PM
Discussion Why does my smaller motor give more thrust ? DaN_Th3_MaN 3D Foamies 13 Jun 17, 2012 01:50 PM
Discussion Why does my Trex can't fly straight asm_ Mini Helis 9 Oct 23, 2007 10:08 AM