Dynamite Passport Ultra voltmeter calibration
I have a Dynamite Passport Ultra and just started using it for lipo batteries and when I try to balance the batteries, the read voltage is always too low by 30mv compared to the other cells i.e. I measured the voltage with a separate voltmeter of all the cells and the relative values which should stay the same were different (is that clear enough). Does anybody know how to fix this? I can't see anything in the software to calibrate the voltmeters is there a way to raise the voltage by 30mv with an external circuit? this is pretty annoying because I am unable to properly balance my batteries...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Dynamite Passport Ultra AC/DC charger||lammbn||Aircraft - Electric - Batteries & Chargers (FS/W)||1||Feb 29, 2012 07:48 PM|
|Sold||Dynamite Passport Ultra Charger (NIB) 95.00||bkent100||Aircraft - Electric - Batteries & Chargers (FS/W)||2||Jan 29, 2011 12:32 PM|
|Mini-Review||Dynamite Passport Ultra Review||bladecpfreek||Batteries and Chargers||1||May 21, 2010 09:57 AM|
|Discussion||Dynamite RC Passport Ultra AC/DC Charger||chickenwing||Batteries and Chargers||3||Feb 24, 2010 09:55 PM|