Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Jun 26, 2012, 05:27 AM
easystarfpv4 is offline
Find More Posts by easystarfpv4
Suspended Account
Question

How do I heat shrink my motor to my my fpv?


Was hoping someone could guide me on how to heat shrink a motor to the fuselage (Easystar) so as not to have to glue it in place to the foam fuselage?


Thank you?
Sign up now
to remove ads between posts
Old Jun 26, 2012, 07:49 AM
jackerbes is offline
Find More Posts by jackerbes
Jack
jackerbes's Avatar
Not sure that heat shrink would be a method that will work. Have you seen this mount that fits in the motor cavity?

http://www.readymaderc.com/store/ind...products_id=13

That would put the motor outside the normal motor housing and you might need a little more battery weight or ballast up front but it is a concept that might work for you.

Jack


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale 5 pairs deans connectors with heat shrink $10 shipped 3drcparts Aircraft - Electric - Batteries & Chargers (FS/W) 0 Jun 25, 2012 06:47 PM
Discussion Turnigy 9x receiver antenna heat shrink part fell off Lpbug FPV Talk 4 Jun 17, 2012 07:50 PM
Discussion Wanted 2", 21/2 clear heat shrink tubing, where? Wild Bill The Builders Workshop 7 Jun 17, 2012 06:27 PM
For Sale 5mm heat shrink tubing $3 shipped 3drcparts Aircraft - Electric - Batteries & Chargers (FS/W) 1 Jun 15, 2012 11:32 PM
Help! How do I stop my heat sink from slipping off motor? Jacques.Eloff Electric Ducted Fan Jet Talk 7 Jan 30, 2009 01:23 AM