Duty Cycle - RC Groups
Thread Tools
Jun 26, 2012, 12:50 AM
Registered User

Duty Cycle


My quad needs 10 channels (due to lots of stuff).
But my radio has only 9.
So I would like to use a PIC to send the AL gain signal and free one channel.

What is the cycle width and positive pulse width range used by hoverflypro?
Sign up now
to remove ads between posts
Jun 26, 2012, 06:18 AM
A man with too many toys
1.0 ms low
1.5 ms center
2.0 ms high

More information http://www.luolamies.org/misc/servo.html

Jun 26, 2012, 11:13 AM
Registered User
These are the positive pulse values. The width range.

But what is the total cycle width?
I mean, the exact values seen by hoverfly pro. I guess that there are some little diferences between diferent manufacturers.
Last edited by periquira; Jun 26, 2012 at 10:13 PM.
Jun 30, 2012, 05:09 PM
Registered User
just use one of the cheap hk servotesters, that would work if you get the gain dialed in while connected to setup program.
best regards

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion PWM adjust Freq and Duty Cycle mazur50 DIY Electronics 15 Jul 04, 2008 02:10 PM
Discussion LIPO Trick #5: 70% Duty Cycle hall woo Batteries and Chargers 0 Oct 17, 2006 01:43 PM
What constitutes a High Duty Cycle? mcharles13 Batteries and Chargers 3 Jul 26, 2005 07:40 PM
What does duty cycle mean ? RPatrick Batteries and Chargers 2 Apr 29, 2005 12:43 AM
Question When was the RFFS 100 s/w code changed to 100% duty cycle? Uttam1 Scratchbuilt Indoor and Micro Models 1 Jul 09, 2004 09:11 AM