Custom Tonka Body for FPV Summit
I made this for my Summit to do FPV as a spare body but there's no need for me to have two. It's basically plug and play ready to your Summit to get it up and running without video gear. The camera housing was made for a GoPro HD Hero 2 but could easily be modified to fit the original HD Hero.
It fits in place of the stock body posts in the same location and is a quick change from the stock body if you want to go back and forth. Just be sure to add preload to the springs as this body is heavier than stock.
Save yourself the hassle of having to square out the holes for the body posts and doing all the cutting and trimming of the steel and plastic to make it fit just right over the Summit.
$130 shipped in the CONUS.
Last edited by healthyfatboy; Jul 02, 2012 at 08:42 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||FPV Tonka Summit||replayreb||FPV Talk||11529||Yesterday 06:01 PM|
|Sold||FPV Tonka Summit||healthyfatboy||FPV Equipment (FS/W)||6||Jun 24, 2012 07:49 PM|
|Discussion||FPV Tonka build log (not a Summit)||Silent_NL||FPV Talk||11||Jun 11, 2012 02:13 PM|