ImmersionRC 5.8Ghz setup suggestions needed
After the crash of my Gaui 500x with gu-ins, gu-osd and fpv with the Racewood 1,2Ghz system i lost everything.
I decided to move to Immersionrc with the v2 5.8Ghz transmitter and the Diversity from Immersionrc also.
I choose for the moment to equip both transmitter and receiver with Pinwheel antennas.
On the first manual test i have done I am very impress by the stability, quality, range by the whole system.
I have 2 questions to complete the setup on my brand new Gaui 500x :
- could someone advise regarding the position of the Pinwheel antenna on the Drone ? I would like to put it vertical but with the head on the bottom ! Any feedback ? The reason is to improve the range and quality in any situation during a flight.
- where could I find connector for the small one (5 pins also) on the opposite side regarding the large black connector ? I would like to use this one because the Gaui gu-osd use the same with a 6 pins version, same for the camera (3 pins version) I would build then a core fpv cable with small connectors for all.
Links url below described my old core fpv cable I built for the Racewood where I was already small connectors and add a sort of extension and adaptor cable for each device (camera, osd, etc...) I didn't need to change all cables each time :
Thanks in advance
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||5.8GHz 600mA ImmersionRC range??||Mechnan||FPV Talk||17||Oct 23, 2014 01:29 AM|
|Discussion||ImmersionRC duo 5.8ghz Rx||barchiola||FPV Talk||71||May 28, 2013 08:07 AM|
|Help!||Need some help getting my HoryzonHD -> ImmersionRC -> Fatshark FPV setup working||Mile_high_club||FPV Talk||5||Jul 23, 2012 09:04 AM|
|Discussion||immersionRC 5.8ghz 600 mw transmitter....||barchiola||FPV Talk||19||Oct 25, 2011 11:35 PM|
|Sold||ImmersionRC 5.8ghz duo 5800 Rx w/ 2 patch antennae||barchiola||FPV Equipment (FS/W)||13||Mar 25, 2011 04:03 PM|