Originally Posted by Maseo54
WHAT THE HECK IS GOING ON??
Need some help.... Went flying with my quad 2 days ago... Today I unplugged the motor /esc leads going to the kk2 to reposition the board on a different spot on my quad. I hooked the motor leads back up in same position. Now my quad flips forward every single freaking time I even think about using the throttle!
I re-calibrated the esc's a gazillion times... Checked receiver setting on kk2 and my dx6i....reset acc... Reset to stock settings..... Tried to dial in pi setting... Used my original pi settings... I did all this a million times and my quad still flips violently forward! All because I unplugged and plugged back in the motor /esc leads??
I've had a couple of kk2's before and this has never happened before. My ailerons and rudder are always set to reverse for my kk2's....I even tried switching them, but again no luck..... Again all directions for receiver are correct when showed on kk2.
Again all i did was unplug and plugged back in my esc/motor leads to the kk2. Any solutions? Bad board? Trash it? Start using a different FC? I'm dumbfounded as to why it's doing this!
Thanks for your help!
happened to me once long time ago...
1. check back your PWM inputs from M1-M4 make sure the connection is correct... if u plug these pins wrong, your quad will flip
2. also check your AIL, ELE,THR,RUD & AUX connection