Help with a KK board, newbie is stuck.
I've been working with a tricopter setup. It's all built, everything is installed. I have a KK board (think it's a clone) all wired up and seems to be working fine. I have this problem, as I apply throttle all rotors start up. At this point the board acts normal, everything responds as it should. Now as I increase the throttle, the right forward motor will stop, the left will continue to power up as does the rear rotor. Increasing throttle, the left motor then stops and the rear rotor continues to run. The board was purchased on the RCG classifieds, and was bought new. I don't have any instructions to follow. I found instructions on the web for a KK board setup for tricopters. I have changed out motors and ESC's but still get the same result. am I missing something? Any suggestions at this time would be grateful. I'm not new to RC, I fly FPV, and would like to try FPV multirotor.
I bet you forgot to do the ESC calibration try this and see what this does also make sure its flashed with the try copter firmware and not a quadcopter firmware i forgot to do the ESC calibration and was like WTH for hours
Here is how you do it...
REMOVE YOUR PROPS BEFORE DOING THIS
-Turn yaw pot to zero.
-Turn on transmitter.
-Throttle stick to full.
-Turn on flight controller.
-Wait until the ESC's beeps twice after the initial beeps. (Plush and SS ESC's)
-Throttle stick to off. ESC's beep.
-Turn off flight controller.
-Restore the yaw pot.
-Power up and give it a go.
This guide has step by step for everything:
Also note that if you're running version 1.6 of the tricopter firmware, the pots are:
Yaw: P and I for yaw
Pitch: I for Roll and Pitch
Roll: P for Roll and Pitch
I didn't know this and had a hell of a time getting my gains set.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||help needed with turnigy x9 and kk board setup||guy1a||Multirotor Drone Talk||6||Apr 18, 2012 03:09 PM|
|Help!||need help with a new multi with kk board||abletowinginc||Multirotor Drone Talk||3||Apr 13, 2012 10:08 AM|
|Discussion||Newb needs help with kk 5.5 board asap please||MOTOSTEIN||Multirotor Drone Talk||0||Feb 11, 2012 06:34 PM|
|Help!||Help with KK board Quad, motors shut down||hogfarmer||Multirotor Drone Talk||24||Jan 27, 2012 07:48 PM|
|Discussion||I need some help with Minsoo Kim KK board||SeismicCWave||Multirotor Drone Talk||1||Apr 08, 2011 06:01 AM|