New Products Flash Sale
Thread Tools
Old Jun 13, 2012, 06:10 PM
ibblind is offline
Find More Posts by ibblind
Registered User
Discussion

Turnigy Centurion Mini Brushless Catamaran ESC Programming help


Nice little boat but cannot find programming info on esc. It's a 30amp esc red in color. No identifying marks on it and the menus are not the same as the turnigy esc's programming but they seem to be very close. Once in programming the beep sequence is as follows.

1 short - 1 short, 2 short, 3 short - not sure
2 short - 1 short, 2 short, 3 short - not sure
3 short - 1 short, 2 short, 3 short - not sure
4 short - 1 short, 2 short - Lipo/Nimh?
1 long - 1 short, 2 short, 3 short - not sure
1 long 1 short - 1 short, 2 short, 3 short, 4 short, 1 long, 1 long 1 short - Timing?
1 long 2 short - 1 short, 2 short, 3 short - not sure
1 long 3 short - 1 short, 2 short - Reset to defaults?
3 long - end point

Any ideas what they might indicate? HK doesnt have a manual on the esc...
Sign up now
to remove ads between posts
Old Sep 03, 2012, 07:35 AM
gavin3171 is offline
Find More Posts by gavin3171
Registered User
mine came pre programmed out the box?
Old Sep 04, 2012, 12:37 AM
boredom.is.me is offline
Find More Posts by boredom.is.me
Micro Boat Forum Founder
boredom.is.me's Avatar
At least a picture please.
Old Aug 09, 2014, 09:26 AM
hexbub is offline
Find More Posts by hexbub
Registered User
I have tried to figure out how to programm the esc either.. I have gone through all available hk speed controllers for boat and couldn't find the pattern I heat after entering the programming mode.
What brougt my attentions was how the "not named" esc looked. It looks like a normal esc re-built for boat usage - I suppose it must be something from the hk esc range - after looking at many speed controllers it seems that it could be something similiart to http://hobbyking.com/hobbyking/store...ontroller.html Blueseries 30A. In the manual http://www.hobbyking.com/hobbyking/s...28X70599X0.pdf the sequence is almost identical.. I have not tried it yet, though..

Regards
Old Aug 16, 2014, 11:27 AM
pompebled is offline
Find More Posts by pompebled
Boaters are nice people.

Suppo.


I'm using these instructions to program my no name/rebranded ESC's:
http://www.suppomodel.com/ESC/Normal..._and_above.pdf

Regards, Jan.
Old Dec 20, 2014, 12:00 PM
spiros is offline
Find More Posts by spiros
Registered User
do you know how much mm is the axle when the rudder is held to?i'm thinking of putting this rudder on my joysway smx


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion can I use my turnigy esc programing card with me rctimer esc? imdone Multirotor Talk 4 Jun 08, 2014 06:14 PM
Question Help with ESC selection and ESC programming Power_user_EX Power Systems 0 May 18, 2012 05:09 AM
Discussion HK Centurion catamaran Shaft!! El cata Racing Boats - Electric 1 May 03, 2012 12:39 PM
Discussion Turnigy programing card.to 120a esc marine Bernhard BB Racing Boats - Electric 13 Oct 20, 2011 09:43 AM
Sold mini catamaran - brushless Vasy Boats (FS/W) 0 Dec 06, 2009 12:02 AM