Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Jun 12, 2012, 04:44 PM
Savage27 is offline
Find More Posts by Savage27
Registered User

TriCopter with HK Board V2

Hi Everyone,

I've build a TriCopter with the instructions from and read most of the Beginners Threads. All Motors and Props are balanced and the HK Board is mounted inside the foam Box, that it was shiped in, from HK.

The first attempt was made using a old Futuba TX, now I've switched to a, still old but already digital Futaba FF-7. I can start the TriCopter and done all the setup for the Pots on the HK board.

Why is it that i have to retrim the TricCopter, after lift of, with the TX ? The triming is changing with every take off. I've already covered the gyros that they don't get direkt sunlight.

Can you give me any advice what to do, to not retrim the Copter after every takeoff ?

Thank you

Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Rave HK KK V2 Quad board (and other recent KK boards) randall1959 Multirotor Electronics 2584 Aug 11, 2014 03:01 PM
Help! Yaw problem with HK KK Board V2.1, KK firmware 4.7 count74 Multirotor Talk 2 Jul 18, 2014 04:37 PM
Help! Problem with HK board v2.1 Arxangel Multirotor Talk 3 Feb 24, 2012 06:37 PM
Help! KK board from HK- free flash for tricopter dougmontgomery Multirotor Talk 1 Dec 10, 2011 04:54 PM
Discussion .hex firmware for hk board tricopter emberjelly Multirotor Talk 1 Sep 25, 2011 06:33 AM