Thread Tools |
This thread is privately moderated by phil alvirez, who may elect to delete unwanted replies. |
|
|
Thread OP
|
Discussion
switch guard for tx
switch guard to prevent accidental activation?
with so many switches all over the transmitters, it's easy to flip 1 inadvertently. i was wondering if there is a way to install a guard to prevent this. or design the tx's in such a way that we can add them at will. for instance, on full size airplanes that have an ejection seat, the switch that activates the ejection has a cover that has to be lifted, to avoid going away unexpectedly. or perhaps an enterprising fellow can come out with an add-on that does not cost an arm and a leg? i hope manufacturers see this and think about it. and that they not only bring the expensive versions with them: all should have it. it's safety-just safety. i got a suggestion to google on ebay and found this: http://www.ebay.com/itm/FLIP-UP-COVE...-/250800634875 and this: http://www.summitracing.com/parts/PCO-5568PT/ i already ordered some of the 1st. just got them.they measure 5/8x1-5/8". too big! they are great, but too large for our tx's. we need something-if it exists-no larger than 3/8x1". will try to get others and see. |
|
Last edited by phil alvirez; Jun 12, 2012 at 06:33 PM.
|
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | How do I modify the trainer switch for Head tracking on Futaba TX? | Kahnx | FPV Talk | 6 | Aug 03, 2012 12:59 AM |
Discussion | switch guard to prevent accidental activation? | phil alvirez | Radios | 20 | Jun 17, 2012 08:50 AM |
Found | retention nut for tx switches | mlwartman | Aircraft - General - Radio Equipment (FS/W) | 2 | May 10, 2012 06:54 AM |
Discussion | using a 6 channel Tx (Dx6i) for a 3 Channel trainer / switching rudder stick | hermanmango | Electric Plane Talk | 4 | Feb 07, 2012 12:59 PM |
Help! | Looking for tiny push button switch for my Tx trim | gtfreeflyer | DIY Electronics | 16 | Nov 26, 2009 01:35 PM |