Bunch of planes and a quadcopter for sale LPU Metro Atlanta
Looking to step into some bigger planes so i am clearing out stuff i no longer fly. Everything is local pickup in north atlanta area (live in kennesaw/acworth and work in chamblee)
- Parkzone F27-Q Stryker
Plane has the typical belly lander wear and tear, its never been crashed the nose has taken some damage from hard landings (most all of my landings were elevator drops).
The plane has been upgraded with the following items:
Turnigy Trust 70A esc w/deans connector
Hitec HS-85MG elevon servos
Dubro XL arms for Elevons
APC 7x5 prop (supposed to do about 93mph in flat level flight)
Comes with spare brand new 7x5 apc prop and stock 6x6 prop. Esc has been moved to the back so the correct CG is now achievable. Plane runs on a 3s 2200mah pack, i was getting consistent 7-8minute flights with some smooth flying and the occasional top speed pass, but the plane slows down extremely well.
Asking $120 for the setup just add your receiver and 3s pack
- Twisted hobbies 32" Edge540 EPP plane
Typical indoor flying dings and dents nothing big or that effect flight. Plane almost hovers itself and is a blast but i dont do much indoor flying so it doesnt get touched
32" Edgo 540 EPP plane from twisted hobby
Tower Pro 9g on aileron
JR Sport SM8 on elevator and rudder
Tiger T1806 2000kv motor
Exceed RC proton 10a esc
8x3.8 APC prop
Parkzone Micro T-28 RTF
Beat this plane up pretty good but it still flies. I believe it either needs a new motor or batteries because i get about a minute of flight time and then the motor starts pulsing and wont restart until i reconnect the battery. Most of the damage is to the front end. I should have the battery charger for it as well.
- Precision Aerobatics Ultimate AMR
Absolutely love this plane but since the wings dont come off it make transportation hard for me. Made a couple small changes to make the plane better. It has never been crashed, however the motorbox and cowl have been replaced due to a motor shaft shearing and one of the previous owners clipped a curb on the wing and it broke one of the ribs. I bought it like this and it has never caused any issue and would be an easy fix with a small covering patch.
PA Ultimate AMR in red/black
Voltec VTS 70MG in the ailerons
Hitec HS65MG's in the tail
Hacker A30-14L 800kv w/ 14x7 APC prop
ZTW 50A esc
Carbon Fiber Spinner
Dubro tail wheel assembly
2x Turnigy 2200mah 3s packs
$250 Firm on this one keeping it isnt a big deal but would like to see somebody enjoy it. Receiver is NOT included.
4 exceed RC motors
4 Dynam Detrum 25A esc's
HK KK stabilization board
Extended length aluminum quad frame
Heli landing gear
Align Battery strap
Parallel battery connector
2x Zippy 3s 2200mah packs (puffed but they work)
This copter is all setup and ready to go just add your receiver and program your radio per the booklet that is included. Some of the fiberglass is cracked due to losing a prop once but it still flies fine.
Last edited by shadow102; May 27, 2012 at 03:12 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Alert||PZ Stryker f-27Q and PA Ultimate AMR Forsale||shadow102||Atlanta Area RC||14||Jun 30, 2012 08:30 PM|
|For Sale||planes 4-sale (LPU) atlanta, ga||gchrisgo34||Aircraft - Electric - Airplanes (FS/W)||5||Jan 25, 2012 09:29 AM|
|Discussion||FYI to Atlanta folks - Big plane & xtras for sale..||bmontini||Atlanta Area RC||0||Sep 26, 2011 11:54 PM|
|Sold||For Sale - Birdie 10 Balsa Pattern Plane LPU Metro Detroit Area||funfly||Aircraft - Fuel - Airplanes (FS/W)||2||Oct 23, 2009 09:57 AM|
|Sold||Birdie 10 Balsa Pattern Plane for Metro Detroit Area LPU||funfly||Aircraft - Electric - Airplanes (FS/W)||4||Oct 22, 2009 12:10 PM|